Bissoy.com
Doctors Medicines MCQs Q&A

The boundary layer thickness at a distance of l m from the leading edge of a flat plate, kept at zero angle of incidence to the flow direction, is O.l cm. The velocity outside the boundary layer is 25 ml sec. The boundary layer thickness at a distance of 4 m is (Assume that boundary layer is entirely laminar)

The boundary layer thickness at a distance of l m from the leading edge of a flat plate, kept at zero angle of incidence to the flow direction, is O.l cm. The velocity outside the boundary layer is 25 ml sec. The boundary layer thickness at a distance of 4 m is (Assume that boundary layer is entirely laminar) Correct Answer 0.20 cm

Related Questions

The laminar boundary layer thickness in zero pressure gradient flow over a flat plate along the x-direction varies as x0.5 while the thickness of turbulent boundary layer varies as (where, x = distance from the leading edge)
Ambient air at 20 degree Celsius flows past a flat plate with a sharp leading edge at 3 m/s. The plate is heated uniformly throughout its entire length and is maintained at a surface temperature of 40 degree Celsius. Calculate the distance from the leading edge at which the flow in the boundary layer changes from laminar to turbulent conditions. Assume that transition occurs at a critical Reynolds number of 500000
In the laminar boundary layer flow over a flat plate, the ratio (δ/x) varies as :(where, 'δ' is the boundary layer thickness and 'x' is the distance from the leading edge in the direction of flow).
In the laminar boundary layer flow over a flat plate, the ratio $$\frac{\delta }{{\text{x}}}$$ varies as: (where, $$\delta $$ is the boundary layer thickness and x is the distance from the leading edge in the direction of flow).
A stream of air at 100 kPa pressure and 300 K is flowing on the top surface of a thin flat sheet of solid naphthalene of length 0.2 m with a velocity of 20 m/sec. The other data are: Mass diffusivity of naphthalene vapor in air = 6 * 10 –6 m2/sec Kinematic viscosity of air = 1.5 * 10 –5 m2.sc Concentration of naphthalene at the air-solid naphthalene interface = 1 * 10 – 5 kmol/m3 Calculate the overage mass transfer coefficient over the flat plate. Note: For heat transfer over a flat plate, convective heat transfer coefficient for laminar flow can be calculated by the equation. Nu = 0.664 ReL1/2 Pr1/3 you may use analogy between mass and heat transfer.
A flat plate 1 m by 1 m is placed in a wind tunnel. The velocity and temperature of free stream air are 80 m/s and 10 degree Celsius. The flow over the whole length of the plate is made turbulent by turbulizing grid placed upstream of the plate. Find the thickness of the hydrodynamic boundary layer at trailing edge of the plate
When there’s flow over a flat plate, there’s laminar boundary layer at the leading edge followed by turbulent boundary layer.
Boundary layer thickness in laminar flow over a flat plate increases as(where, d = distance from the leading edge.)
Boundary layer thickness in laminar flow over a flat plate increases as (where, d = distance from the leading edge.)
A flat plate was positioned at zero incidence in a uniform flow stream of air. Assuming boundary layer to be turbulent over the entire plate, workout the ratio of skin-friction forces on the front and rear half part of the plate