Bissoy.com
Doctors Medicines MCQs Q&A

Other non-conventional processes lay behind Laser beam machining in drilling process because of which factors below?

Other non-conventional processes lay behind Laser beam machining in drilling process because of which factors below? Correct Answer All of the mentioned

Other non-conventional processes need high costs for tools, long lead times, and low machining speeds when compared to LBM.

Related Questions

Arrange the processes in the increasing order of their maximum material removal rate. Electrochemical Machining (ECM) Ultrasonic Machining (USM) Electron Beam Machining (EBM) Laser Beam Machining (LBM) and Electric Discharge Machining (EDM)
Consider the following statements with regards to the shear force diagram for the beam ABCD: 1. The beam ABCD is an overhanging beam having supports at A and D only. 2. The beam carries a point load of 20 kN at C. 3. The beam carries a concentrated load of 10 kN at the end B. 4. The beam is an overhanging beam having supports at C and D only. 5. The beam carries a uniformly distributed load of 70 kN over the left hand portion AC only. Which of the above statements are correct?
Consider the following statements regarding types of supports and beams: 1. When both supports of beams are roller supports, the beam is known as simply supported beam. 2. A beam with one end fixed and the other end free is known as fixed beam. 3. A beam with both ends fixed is known as cantilever beam. 4. A beam with one end fixed and the other simply supported is known as propped cantilever. Which of the above statements is/are correct ?
Which of the following are different laser drilling processes in Laser beam machining?
In laser beam machining process, as compared to other unconventional machining processes, heat affected zone is
Two processes X and Y need to access a critical section. Consider the following synchronization construct used by both the processes Process ? /* other code for process ? */ while(true) { varP = true; while(varQ == true) { /* Critical Section */ varP = false; } } /* other code for process ?? */   Process ? /* other code for process ? */ while(true) { varQ = true; while(varP == true) { /* Critical Section */ varQ = false; } } /* other code for process ? */   Here, varP and varQ are shared variables and both are initialized to false. Which one of the following statements is true?
In which of the following cases, there exists the situation of Pure Bending in some part of the beam or along the entire beam? i) A simply supported beam subjected to two equally spaced downward concentrated loads ii) A simply supported beam subjected to two equally spaced opposite moments iii) A cantilever beam subjected to clockwise moment at free end iv) An overhanging beam with both side overhangs subjected to different concentrated loads at both the free ends
Children are in pursuit of a dog whose leash has broken. James is directly behind the dog. Ruby is behind James. Rachel is behind Ruby. Max is ahead of the dog walking down the street in the opposite direction. As the children and dog pass, Max turns around and joins the pursuit. He runs in behind Ruby. James runs faster and is alongside the dog on the left. Ruby runs faster and is alongside the dog on the right. Which child is directly behind the dog?
Which of the following statements are correct? A. Laser printers use dry ink B. Unlike dot matrix and inkjet printers, laser printers do not use ink when producing a document C. Laser printers use the property of static electricity D. Laser printers produce ozone gas and tiny toner particulates in the air Choose the correct answer from the options given below
What is the depth-to-diameter ratio obtained in drilling process using Laser beam machining?