Bissoy.com
Doctors Medicines MCQs Q&A

In laser beam machining process, as compared to other unconventional machining processes, heat affected zone is

In laser beam machining process, as compared to other unconventional machining processes, heat affected zone is Correct Answer Smaller

In laser beam machining process heat affected zone have smaller area in comparison with other unconventional machining processes. It does not require vacuum environment.

Related Questions

Which of the following sequence of Heat zones is/are correctly placed? A) Torrid zone, South temperate zone and Frigid zone. B) Torrid zone, North temperate zone and Frigid zone. C) South temperate zone, torrid zone and Frigid zone. Select the correct answer given below.
Arrange the processes in the increasing order of their maximum material removal rate. Electrochemical Machining (ECM) Ultrasonic Machining (USM) Electron Beam Machining (EBM) Laser Beam Machining (LBM) and Electric Discharge Machining (EDM)
Consider the following statements with regards to the shear force diagram for the beam ABCD: 1. The beam ABCD is an overhanging beam having supports at A and D only. 2. The beam carries a point load of 20 kN at C. 3. The beam carries a concentrated load of 10 kN at the end B. 4. The beam is an overhanging beam having supports at C and D only. 5. The beam carries a uniformly distributed load of 70 kN over the left hand portion AC only. Which of the above statements are correct?
Consider the following statements regarding types of supports and beams: 1. When both supports of beams are roller supports, the beam is known as simply supported beam. 2. A beam with one end fixed and the other end free is known as fixed beam. 3. A beam with both ends fixed is known as cantilever beam. 4. A beam with one end fixed and the other simply supported is known as propped cantilever. Which of the above statements is/are correct ?
Two processes X and Y need to access a critical section. Consider the following synchronization construct used by both the processes Process ? /* other code for process ? */ while(true) { varP = true; while(varQ == true) { /* Critical Section */ varP = false; } } /* other code for process ?? */   Process ? /* other code for process ? */ while(true) { varQ = true; while(varP == true) { /* Critical Section */ varQ = false; } } /* other code for process ? */   Here, varP and varQ are shared variables and both are initialized to false. Which one of the following statements is true?
In which of the following cases, there exists the situation of Pure Bending in some part of the beam or along the entire beam? i) A simply supported beam subjected to two equally spaced downward concentrated loads ii) A simply supported beam subjected to two equally spaced opposite moments iii) A cantilever beam subjected to clockwise moment at free end iv) An overhanging beam with both side overhangs subjected to different concentrated loads at both the free ends
Which of the following are different laser drilling processes in Laser beam machining?
Which of the following statements are correct? A. Laser printers use dry ink B. Unlike dot matrix and inkjet printers, laser printers do not use ink when producing a document C. Laser printers use the property of static electricity D. Laser printers produce ozone gas and tiny toner particulates in the air Choose the correct answer from the options given below
Other non-conventional processes lay behind Laser beam machining in drilling process because of which factors below?
The following zones are formed in a polluted river under the self – purification process 1) zone of clear water (2) zone of active decomposition (3) zone of recovery (4) zone of pollution The correct sequence in which these zones occur progressively downstream in a polluted river is: