Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Two centrifugal pumps P and R are available for use in a pipe flow system and their head-discharge characteristics are as follows. Pump P Pump R Discharge (cumecs) Head (m) Discharge (cumecs) Head (m) 0 40 0 45 0.12 35 0.14 40 0.2 28 0.24 35 0.3 18 0.3 28   The following statements (S1, S2, and S3) pertain to the head and discharge values during actual operation. Neglect losses in the system. Which of the following statements are correct? S1: When the two pumps P and R are connected in parallel, the discharge is 0.36 cumecs corresponding to a head of 35 m. S2: When the two pumps P and R are connected in parallel, the discharge is 0.36 cumecs corresponding to a head of 70 m. S3: When the two pumps P and R are connected in series, the discharge is 0.3 cumecs corresponding to a head of 46 m.
Arrange the processes in the increasing order of their maximum material removal rate. Electrochemical Machining (ECM) Ultrasonic Machining (USM) Electron Beam Machining (EBM) Laser Beam Machining (LBM) and Electric Discharge Machining (EDM)
Few large holes are _________ than many small flushing holes in Electro discharge machining.
State whether the following statement is true or false regarding the dielectric in EDM. “In EDM, flushing through the tool is more preferred than side flushing.”
Bernoulli's equation for fluid flow is derived following certain assumptions. Out of the assumptions listed below, which set of assumptions is used in derivation of Bernoulli's equation?
1. Fluid flow is frictionless & irrotational
2. Fluid flow is steady
3. Fluid flow is uniform & turbulent
4. Fluid is compressible
5. Fluid is incompressible
In electro-discharge machining, dielectric is used to
What is the function of dielectric circulation unit in Electro discharge machining?
In Electro discharge machining, which type of dielectric flow mentioned below is desirable?
Using of a mate electrode in Electro discharge machining _____________ the surface roughness of material.
Which type of electrode is used for drilling in Electro discharge machining?