Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Two centrifugal pumps P and R are available for use in a pipe flow system and their head-discharge characteristics are as follows. Pump P Pump R Discharge (cumecs) Head (m) Discharge (cumecs) Head (m) 0 40 0 45 0.12 35 0.14 40 0.2 28 0.24 35 0.3 18 0.3 28   The following statements (S1, S2, and S3) pertain to the head and discharge values during actual operation. Neglect losses in the system. Which of the following statements are correct? S1: When the two pumps P and R are connected in parallel, the discharge is 0.36 cumecs corresponding to a head of 35 m. S2: When the two pumps P and R are connected in parallel, the discharge is 0.36 cumecs corresponding to a head of 70 m. S3: When the two pumps P and R are connected in series, the discharge is 0.3 cumecs corresponding to a head of 46 m.
Arrange the processes in the increasing order of their maximum material removal rate. Electrochemical Machining (ECM) Ultrasonic Machining (USM) Electron Beam Machining (EBM) Laser Beam Machining (LBM) and Electric Discharge Machining (EDM)
The following question, there are three statements I, II and III. Read the question carefully and mark your answer according to which statements(s) is/are sufficient to the answer the question. What proportion of liquid of type C is there in the tank of capacity 60 liters after 2 minutes if the tank is initially empty? Statement I: Three pipes P, Q, R fill the tank in 15 minutes, 12 minutes and 10 minutes respectively Statement II: When the tank was empty all the three pipes are opened and they discharge three different types of liquid Statement III: Pipe P discharge type A liquid, pipe Q discharge type B liquid and Pipe R discharge type C liquid
In electro-discharge machining, dielectric is used to
What is the function of dielectric circulation unit in Electro discharge machining?
Electrode orbiting ________ the flushing of dielectric fluid in Electro discharge machining.
Which of the following electrodes are used for machining spherical surfaces in Electro discharge machining?
Which motion of tool is used for machining spherical surfaces in Electro discharge machining?
What are the surface roughness values obtained while machining spherical surfaces using Electro discharge machining?
How much amount of burr is produce when we use Wire Electro discharge machining for machining of work pieces?