Bissoy.com
Doctors Medicines MCQs Q&A

State whether the following statement is true or false regarding the dielectric in EDM. “In EDM, flushing through the tool is more preferred than side flushing.”

State whether the following statement is true or false regarding the dielectric in EDM. “In EDM, flushing through the tool is more preferred than side flushing.” Correct Answer True

Flushing through the tool is preferred than side flushing for deep cuts.

Related Questions

State whether the following statement is true or false regarding the surface roughness in EDM. “In EDM, graphite electrodes produce smoother surfaces than metal ones.”
State whether the following statement is true or false regarding EDM. “In EDM, process is affected by hardness of material.”
State whether the following statement is true or false regarding EDM. “In EDM, negative ions (electrons) collide with positive ions to generate heat.”
State whether the following statement is true or false regarding wear in EDM. “In EDM, electrode wear is less dominant when it comes to micromachining applications.”
State whether the following statement is true or false regarding wear in EDM. “In EDM, corner wear ratio does not depend on type of electrode material.”
State whether the following statement is true or false regarding the HAZ in EDM. “In EDM, post treatment to recover fatigue strength is not recommended.”
State whether the following statement is true or false regarding the applications of EDM. “In advanced machining processes, the incorporation of EDM with CIM increased the length of time for unit operation.”
State whether the following statement is true or false regarding the applications of EDM. “In EDM, milling process can machine complex shapes with sharp corners.”
Which of the following forces are measured directly by strain gauges or force dynamometers during metal cutting? 1. Force exerted by the tool on the chip acting normally to the tool face 2. Horizontal cutting force exerted by the tool on the workpiece 3. Frictional resistance of the tool against the chip flow acting along the tool face 4. Vertical force which helps in holding the tool in position Select the correct answer using the codes given below.
What happens to the dielectric flushing while milling tool is rotated at a high speed in EDM?