Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

State whether the following statement is true or false, about Abrasive jet machining. “Using Abrasive jet machining, micro deburring of hypodermic needles can take place.”
What is the value of abrasive grain flow rate in Abrasive jet machining?
Abrasive flow value in Abrasive water jet machining will range between which of the following values?
When compared to Abrasive water jet machining, how are the material removal rates in Ice jet machining?
Arrange the processes in the increasing order of their maximum material removal rate. Electrochemical Machining (ECM) Ultrasonic Machining (USM) Electron Beam Machining (EBM) Laser Beam Machining (LBM) and Electric Discharge Machining (EDM)
A GSM cellular telephone standard requires a minimum of 9 dB rejection of interfering signal levels of -23 dBm at 3 MHz from the carrier, -33 dBm at 1.6 MHz from the carrier, and -43 dBm at 0.6 MHz from the carrier, for a carrier level of -99 dBm. Determine the required local oscillator phase noise at 3 MHz carrier frequency offset.
Consider the following statements with reference to Jet stream. 1. The Jet Stream is a geostrophic wind. 2. There are two permanent jet streams – subtropical jets at mid-latitudes and polar front jets at lower latitudes. 3. Temperature also influences the velocity of the jet stream. The lower the difference in air temperature, the faster the jet stream. Which of the statements given above is/are NOT correct?
In Abrasive jet machining, what may be the size of the abrasive grains used?
What is the grain size of abrasive particles, which are often used for Abrasive water jet machining?
In a newly developed innovative idea brought up by CSIR in India, gas turbine exhaust gas are being utilized to convert feedwater into steam. Certain data of the experiment are as follows: mass flow rate of exhaust gas = 40 kg/hr, enthalpy of exhaust gas at the time of their exit from gas turbine is 600 kJ/kg, steam turbine output as measured by brake dynamometer = 60 hp-sec, thermal efficiency of steam power plant is 0.25, efficiency of exhaust gas in converting feedwater into steam is taken as 50%. Find the enthalpy of exhaust gas remaining after they generate steam from feedwater?