Bissoy.com
Doctors Medicines MCQs Q&A

A window having area of 2m^2 has a surface temperature of 15°C and the air is blowing at 2°C across it with convection heat transfer coefficient of h = 125 W/m2K. Find the total heat transfer loss?

A window having area of 2m^2 has a surface temperature of 15°C and the air is blowing at 2°C across it with convection heat transfer coefficient of h = 125 W/m2K. Find the total heat transfer loss? Correct Answer 3250 W

Total heat transfer loss = h A ∆T = 125*2*(15-2) = 3250 W.

Related Questions

A 2 m2 window has a surface temperature of 15°C and the outside wind is blowing air at 2°C across it with a convection heat transfer coefficient of h = 125 W/m2K. What is the total heat transfer loss?
The rear window of an automobile is made of thick glass i.e. AB = 5 mm and thermal conductivity is 0.8 W/m degree. To defrost this window, a thin transparent film type heating element has been fixed to its inner surface. For the conditions given below, determine the electric power that must be provided per unit area of window if a temperature 5 degree Celsius is maintained at its outer surface. Interior air temperature and the corresponding surface coefficient are 20 degree Celsius and 12 W/m2 degree. Surrounding air temperature and the corresponding surface coefficient are – 15 degree Celsius and 70 W/m2 degree. Electric heater provides uniform heat flux
A polished metal pipe 5 cm outside diameter and 370 K temperature at the outer surface is exposed to ambient conditions at 295 K temperature. The emissivity of the surface is 0.2 and the convection coefficient of heat transfer is 11.35 W/m2 degree. Calculate the overall coefficient of heat transfer by the combined mode of convection and radiation
On a winter day with atmospheric air at −15°C, the outside front wind-shield of a car has surface temperature of +2°C, maintained by blowing hot air on the inside surface. If the wind-shield is 0.5 m2 and the outside convection coefficient is 250 W/Km2, find the rate of energy loss through front wind-shield.
On a clear night there is radiation from earth’s surface to space. On such a night, the water particles on the plant leaves radiate to the sky whose temperature may be taken as 200 K. The water particles receive heat by convection from the surrounding air, the convection heat transfer coefficient has a value of 30 W/m2 K. If the water should not freeze, make calculations for the air temperature
A stream of air at 100 kPa pressure and 300 K is flowing on the top surface of a thin flat sheet of solid naphthalene of length 0.2 m with a velocity of 20 m/sec. The other data are: Mass diffusivity of naphthalene vapor in air = 6 * 10 –6 m2/sec Kinematic viscosity of air = 1.5 * 10 –5 m2.sc Concentration of naphthalene at the air-solid naphthalene interface = 1 * 10 – 5 kmol/m3 Calculate the overage mass transfer coefficient over the flat plate. Note: For heat transfer over a flat plate, convective heat transfer coefficient for laminar flow can be calculated by the equation. Nu = 0.664 ReL1/2 Pr1/3 you may use analogy between mass and heat transfer.
Forced air flows over a convection heat exchanger in a room heater, resulting in a convective heat transfer coefficient 1.136 k W/m2 K. The surface temperature of heat exchanger may be considered constant at 65 degree Celsius, and the air is at 20 degree Celsius. Determine the heat exchanger surface area required for 8.8 k W of heating
A finned surface consists of root or base area of 1m2 and fin surface area of 2m2. The average heat transfer coefficient for finned surface is 20W/m2K effectiveness of fins provided is 0.75. If finned surface with surface with root or base temperature of 50°C is transferring heat to fluid of 30°C, then the rate of heat transfer without using fin is _______
An average convective heat transfer coefficient for flow of air over a sphere has been measured by observing the temperature-time history of a 12 mm diameter copper sphere (density = 9000 kg/m3 and c = 0.4 k J/kg K) exposed to air at 30 degree Celsius. The temperature of the sphere was measured by two thermocouples one located at the center and the other near the surface. The initial temperature of the ball was 75 degree Celsius and it decreased by 10 degree Celsius in 1.2 minutes. Find the heat transfer coefficient
The oven of an electric store, of total outside surface area 2.9 m2 dissipates electric energy at the rate of 600 W. The surrounding room air is at 20 degree Celsius and the surface coefficient of heat transfer between the room air and the surface of the oven is estimated to be 11.35 W/m 2 degree. Determine the average steady state temperature of the outside surface of the store