Bissoy.com
Doctors Medicines MCQs Q&A

Consider the following characteristics: 1. Small interference 2. Strong tooth. 3. Low production cost 4. Gear with small number of teeth. Those characteristics which are applicable to stub 20° involute system would include

Consider the following characteristics: 1. Small interference 2. Strong tooth. 3. Low production cost 4. Gear with small number of teeth. Those characteristics which are applicable to stub 20° involute system would include Correct Answer 2, 3 and 4

Involute system is very interference prone.

Related Questions

The interference between a given pinion tooth and a gear tooth can be avoided by using 1. smaller pressure angle 2. larger pressure angle 3. Less number of teeth on the gear for a pinion with predefined number of teeth 4. More number of teeth on the gear for a pinion with predefined number of teeth Which of the above statements are correct?
A planetary gear train is shown in the figure. Number of teeth on the sun gear A, planet gear B and fixed ring gear D are given by 30, 70 and 140 respectively. Module is taken as 5mm. A pair of spur gears consist of 25 teeth pinion meshing with a 115 teeth gear. The module is 5mm. Calculate the gear ratio.
A gear train consist of spur gear as shown. Gear A receives 4kW of power at 750rpm through its shaft and rotates in CW direction. A gear train consist of spur gear as shown. Gear A receives 4kW of power at 750rpm through its shaft and rotates in CW direction. Calculate the torque on the gear C if number of teeth on gear A, B and C are 40, 70 and 30.
A certain dentist specializes in implanting gold and silver teeth in his patients mouths .He charges $ 650 for a gold tooth an $ 325. for a silver tooth. If his told fees for implanting gold and silver teeth last week were $ 15, 925 in total and he implanted five more gold teeth that silver teeth, how many teeth in total did he implant over the week?
Consider the following statements: A 200 stub tooth system is generally preferred in spur gears as it results in 1. stronger teeth 2. lesser number of teeth on the pinion 3. lesser chances of surface fatigue failure 4. reduction of interference Which of the above statements are correct?
A planetary gear train is shown in the figure. Number of teeth on the sun gear A, planet gear B and fixed ring gear D are given by 30, 70 and 140 respectively. Module is taken as 5mm. Calculate the tangential component of gear tooth force.
Consider the following statements regarding gear tooth designing for gear drive: 1. Tooth profiles not designed as per ‘law of gearing’ will cause vibration and impact problems even at low speed. 2. As the gears go through their mesh, the pitch point must remain stationary on the line of centres. 3. In a correctly designed tooth profile, the line of action of successive instantaneous points of contact will pass through the stationary pitch point. Which of the above statements are correct?
Consider the following statements: 1. A stub tooth has a working depth larger than that of a full-depth tooth. 2. The path of contact for involute gears is an arc of a circle. Which of the statements given above is/are correct?
A fixed gear having 200 teeth is in mesh with another gear having 50 teeth. The two gears are connected by an arm. The number of turns made by the smaller gear for one revolution of arm about the centre of bigger gear is
The velocity ratio between pinion and gear in a gear drive is 2.3, the module of teeth is 2.0 mm and sum of number of teeth on pinion and gear is 99. What is the centre distance between pinion and the gear?