Bissoy.com
Doctors Medicines MCQs Q&A

In a multiple V-belt drive, if one of the belt is broken, then we should replace

In a multiple V-belt drive, if one of the belt is broken, then we should replace Correct Answer all the belts

In multiple V-belt drive, all the belts should stretch at the same rate so that the load is equally divided between them. When one of the set of belts break, the entire set should be replaced at the same time. If only one belt is replaced, the new unworn and unstressed belt will be more tightly stretched and will move with different velocity.

Related Questions

Consider the following statements regarding V-belt drive : 1. The groove angle of the sleeve is less than the belt section angle 2. The efficiency of a V-belt drive is higher than that of a flat belt drive 3. The groove angle is so made that the belt gets wedged in the groove  Which of the above statements are correct ? 
In a multiple V-belt drive, if one of the belts is broken, then we should replace
In a flat belt drive, if the slip between the driver and belt is 1%, between the belt and follower is 3% and driver and follower pulley diameters are equal, then velocity ratio of the drive will be
The efficiency of flat belt drive is 35%. If all the parameters are same and flat belt is replaced by V belt, than the efficiency of V belt will be?
For a flat open-belt drive, the belt speed is 880 m/min and the power transmitted is 22.5 kW. What is the difference between the tight side and slack side tensions of the belt drive?
Which one of the following four addresses is NOT EXACTLY same as the one given below? Cabramatta 360 Elizabeth Drive, 2170 Mount Pritchard, Australia (i) Cabramatta 360 Elizabeth Drive, 2170 Mount Pritchard, Australia (ii) Cabramatta 360 Elizabeth Drive, 2170 Mount Pritchard, Australia (iii) Cabrematta 360 Elizabeth Drive, 2170 Mount Pritchard, Australia (iv) Cabramatta 360 Elizabeth Drive, 2170 Mount Pritchard, Australia
Which one of the following four addresses is NOT EXACTLY same as the one given below?  Kedrick Shaw 72 Glenwood Drive, Thornton, NSW 2322, Australia (i)  Kedrick Shaw  72 Glenwood Drive,  Thornton, NSW 2322, Australia (ii) Kedrick Shaw  72 Glenwood Drive,  Thornton, NSW 2322, Australia (iii) Kedrick Shaw  72 Glenwood Drive,  Thornton, NSW 2322, Australia (iv) Kedrick Shaw  72 Glemwood Drive,  Thornton, NSW 2322, Australia
When the belt is transmitting maximum power, the belt speed should be (Where, m = mass of belt per meter (kg/m) and Pmax = maximum permissible tension in belt (N))
When the belt is transmitting maximum power, the belt speed should be
(Where, m = mass of belt per meter (kg/m) and Pmax = maximum permissible tension in belt (N))
A bucket wheel excavator with 20 buckets of capacity 0.5 m3 each, rotates at 5 rev/min. The bucket fill factor is 80%. The excavator loads on to 1200 mm wide belt conveyor. The cross-section area (m2) of the material on the belt is 0.1B2, where B is the belt width in m. The minimum speed of the belt in m/s to avoid spillage of material is