Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

“What is the different between height and radius of solid cylinder?” Which of the following option is sufficient alone to find the answer? A) A solid cylinder is made by melting a solid sphere. The radius of cylinder is 3 times the radius of a circle whose area is 154 sq.m. Height of cylinder is equal to the height of cone whose volume is 2772 cubic meters. B) Area of a rectangle whose longer side is ¾ times the radius of a solid cylinder, is 168 sq.m and, Volume of solid cylinder is 2772 cubic meters and its height is 18 m. C) A metallic cone of radius 15m and height 35m is melted into the solid cylinder of radius equal to the radius of a circle whose area is equal to the area of rectangle whose sides are in the ratio 4 : 3 respectively. D) The curved surface area of the solid cylinder is 3 time the surface area of a sphere of radius 7m and height of cylinder is equal to the height of a metallic cone whose curved surface area is 308 sq.m. 
Manifold _____________ is eliminated due to the fuel being injected into or close to the cylinder and need not flow through the manifold.
The timing at which the injection of the fuel takes place inside the inlet manifold is called _____________ timing.
In an electronic fuel injection system, the ECU calculates the optimum fuel injection volume for the current engine condition based on data from a wide range of sensor, and it injects this volume of fuel into the intake manifold at the optimum timing.
A six cylinder, four-stroke diesel engine develops 125 kW at 3000 rpm. Its brake specific fuel consumption is 200gm/kW h. Calculate the quantity of fuel to be injected per cycle per cylinder. Specific gravity of the fuel may be taken as 0.85.
A solid-oxide fuel cell is fed with carbon monoxide and reacts with air to produce CO2. This reaction will produce 2 electrons which are used to power an electric circuit external to the fuel cell. The reaction equation is shown below: 2CO(g) + O2(g) -> 2CO2(g) ΔHr° = -565.96 kJ/mol This reaction does not occur for other types of fuel cells which use a catalyst, such as polymerelectrolyte membrane or phosphoric-acid fuel cells. The presence of carbon monoxide on the anode side of these types of fuel cells will cause catalyst poisoning, reducing the efficiency and voltage of the fuel cell. Determine the rate of enthalpy change for a carbon dioxide production rate of 208 mol/hr. The extent of the reaction occurring in the fuel cell can be obtained by the following equation: where:
In IC engine 1. the ideal air capacity of a two-stroke engine is the mass of air required to concurrently fill the total cylinder volume at inlet temperature and exhaust pressure 2. with increase in air-fuel ratio beyond the value for maximum power, there is a fall in power developed and this fall is more with higher values of air-fuel ratio. 3. the volumetric efficiency of the engine depends on the design of intake and exhaust manifold. Which of the above are correct?
Just before the piston reaches TDC during exhaust stroke, injection of the fuel takes place into the inlet manifold of the cylinder at about 60º crankangle before TDC.
The curved surface area of cylinder A is 8% more than the curved surface area of cylinder B. If the height of cylinder A is 4% less than the height of cylinder B, then the volume of cylinder A is what percentage more/less than the volume of cylinder B?
The curved surface area of cylinder X is 45% of the curved surface area of cylinder Y. If the volume of cylinder X is 27% of the volume of cylinder Y, then the height of cylinder X is what percentage of the height of cylinder Y?