Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

The interference between a given pinion tooth and a gear tooth can be avoided by using 1. smaller pressure angle 2. larger pressure angle 3. Less number of teeth on the gear for a pinion with predefined number of teeth 4. More number of teeth on the gear for a pinion with predefined number of teeth Which of the above statements are correct?
The velocity ratio between pinion and gear in a gear drive is 2.3, the module of teeth is 2.0 mm and sum of number of teeth on pinion and gear is 99. What is the centre distance between pinion and the gear?
A gear train consist of spur gear as shown. Gear A receives 4kW of power at 750rpm through its shaft and rotates in CW direction. A gear train consist of spur gear as shown. Gear A receives 4kW of power at 750rpm through its shaft and rotates in CW direction. Calculate the torque on the gear C if number of teeth on gear A, B and C are 40, 70 and 30.
A planetary gear train is shown in the figure. Number of teeth on the sun gear A, planet gear B and fixed ring gear D are given by 30, 70 and 140 respectively. Module is taken as 5mm. A pair of spur gears consist of 25 teeth pinion meshing with a 115 teeth gear. The module is 5mm. Calculate the gear ratio.
If the centre distance between a pair of spur gears in mesh is 240 mm and the pinion moves five times faster than the gear, then the pitch circle diameters of pinion and gear respectively are
Following is the data for transmission system of a Gear box reduction ratios.
1st gear - 4.3 : 1
2nd gear - 3.00 : 1
3rd gear - 2.71 : 1
4th gear - 1 : 1
Final drive reduction is 5.0 : 1
The overall reduction when the vehicle is driven in 2nd gear is
The angular velocity of the pinion is 75 rpm and that of the gear is 25 rpm. The addendum radius is 45 mm for the pinion and the radius of the pinion is 40 mm. The pressure angle between the gears is 25°. Find the velocity of sliding at the end of the contact.
Assertion (A): All the mesh currents are necessarily the loop currents but all the loop currents may not be the mesh current. Reason (R): The mesh current is the current which flows only around the perimeter of a mesh.
Statement (I): The epicyclic gear train has a central gear and an epicyclic gear which produces epicyclic motion being moved by a crank arm. Statement (II): The arm contains the bearings for the epicyclic gear to maintain two gears in mesh. 
A fixed gear having 200 teeth is in mesh with another gear having 50 teeth. The two gears are connected by an arm. The number of turns made by the smaller gear for one revolution of arm about the centre of bigger gear is