Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

When a closely-coiled helical spring of mean diameter (D) is subjected to an axial load (W), the deflection of the spring ($$\delta $$) is given by (where d = Diameter of spring wire, n = No. of turns of the spring and C = Modulus of rigidity for the spring material)
A closely coiled helical spring is acted upon by an axial force. The maximum shear stress developed in the spring is $$\tau $$. The half of the length of the spring if cut off and the remaining spring is acted upon by the same axial force. The maximum shear stress in the spring in new condition will be
An open coiled helical compression spring 'A' of mean diameter 50 mm is subjected to an axial load ‘W’. Another spring 'B' of mean diameter 25 mm is similar to spring 'A' in all respects. The deflection of spring 'B' will be __________ as compared to spring 'A'.
When an open coiled helical compression spring is subjected to an axial compressive load, the maximum shear stress induced in the wire is (where D = Mean diameter of the spring coil, d = Diameter of the spring wire, K = Wahl's stress factor and W = Axial compressive load on the spring)
Consider the following statements: In case of helical gears, teeth are cut at an angle to the axis of rotation of the gears. 1) Helix angle introduces another ratio called axial contact ratio. 2) Transverse contact ratio is equal to axial contact ratio in helical gears. 3) Large transverse contact ratio does not allow multiple teeth to share the load. 4) Large axial contact ratio will cause larger axial force component Which of the above statements are correct?
Consider the following statements in connection with deflection-type and null-type instruments: 1. Null-type instruments are more accurate than the deflection-type ones. 2. Null-type of instrument can be highly sensitive compared to a deflection-type instrument. 3. Under dynamic conditions, null-type instruments are less preferred to deflection-type instruments. 4. Response is faster in null-type instruments as compared to deflection-type instruments. Which of the above statements are correct?
Two closely-coiled helical springs 'A' and 'B' of the same material, same number of turns and made from same wire are subjected to an axial load W. The mean diameter of spring 'A' is double the mean diameter of spring 'B'. The ratio of deflections in spring 'B' to spring 'A' will be
When an open coiled helical compression spring is subjected to an axial load (W), the compression produced in the spring will be (where, n = No. of active turns of the spring and G = Modulus of rigidity for the spring material)
Consider the following statements for deflection and null type instruments: 1. Deflection type of instruments are more accurate than null type of instruments. 2. Deflection type of instruments can be highly sensitive as compared with the null type of instruments. 3. Null type of instruments are more suitable for measurements under dynamic conditions than deflection type of instruments. Which of the above statements are not correct?
Some small cubes of same height 7 cm but variable length and width are put inside a large cuboid of height 21 cm. Length and width of cuboid is 32 cm and 24 cm, respectively. Small cubes are put such that cubes at the bottom most layer is of similar base area; second layer contains all the cubes of similar base area and third layer have all the cubes of similar base area. Which of the following statement(s) given below is / are TRUE? A: If side of each small cubes at bottom most layer is 8 cm, then maximum number of small cubes that can be put at bottom most layer is 12. B: If maximum of 48 cubes can be put at second layer, then side of each cube at second layer is 6 cm. C: If side of each small cubes at third layer is 1.6 cm, then maximum number of small cubes that can be put at third layer is 300.