Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

The diameter of knuckle pin in a knuckle joint is usually taken as (where d = Diameter of the rod)
Which of the following are components of the knuckle joint assembly?  I) Knuckle pin II) Single eye III) Double-eye
If knuckle joint is to fail by crushing failure of pin in fork, then determine the diameter of knuckle pin when 50kN axial tensile force act on rods. Given: Max allowable compressive stress=25N/mm², thickness of each eye of fork=25mm.
A, B and C are three places such that there are three different roads from A to B, four different roads from B to C and three different roads from A to C. In how many different ways can one travel from A to C using these roads?
A maximum of how many rods may be connected using a knuckle joint?
Statement: Some buses are roads. All tables are roads. Conclusion: I. Some buses are table. II. Some tables are buses. III. Some roads are tables. IV. Some roads are buses.
In the following question below are given some statements followed by some conclusions. Taking the given statements to be true even if they seem to be at variance from commonly known facts, read all the conclusions and then decide which of the given conclusion logically follows the given statements. Statements: No pink is a park. All pink are roads. Some dolls are roads. No doll is a ball. Conclusions: I. Some roads are not ball. II. Some pink are dolls. III. All park can be roads. IV. No park is a ball.
Practical dividing line between a ductile and brittle materials is suggested, when the ultimate elongation is about 5%. Generally, larger the knuckle radius, stronger is the corner torus section of a head. The knuckle radius provided should be less than __________ of the head.
In case of joint products, the main objective of accounting of the cost is to apportion the joint costs incurred up to the split off point. For cost apportionment one company has chosen Physical Quantity Method. Three joint products ‘A’, ‘B’ and ‘C’ are produced in the same process. Up to the point of split off the total production of A, B and C is 60,000 kg, out of which ‘A’ produces 30,000 kg and joint costs are Rs 3,60,000. Joint costs allocated to product A is.
A knuckle joint is also called socket pin joint.