Bissoy.com
Doctors Medicines MCQs Q&A

In abrasive jet machining, material is removed by shear as well as brittle deformation of the material.

In abrasive jet machining, material is removed by shear as well as brittle deformation of the material. Correct Answer True

If the KE of the abrasive particle is high enough, then it will remove the material by shear deformation in case of ductile workpiece material and by brittle fracture if workpiece material is brittle.

Related Questions

State whether the following statement is true or false, about Abrasive jet machining. “Using Abrasive jet machining, micro deburring of hypodermic needles can take place.”
Which of the following factors are affecting critical shear stresses? 1. Purity of metals reduces the critical shear stress 2. Surface films greatly enhance the critical shear stress 3. Rise in temperature 4. Rate of deformation and the extent of initial deformation also help in raising the critical shear stress
When compared to Abrasive water jet machining, how are the material removal rates in Ice jet machining?
Arrange the processes in the increasing order of their maximum material removal rate. Electrochemical Machining (ECM) Ultrasonic Machining (USM) Electron Beam Machining (EBM) Laser Beam Machining (LBM) and Electric Discharge Machining (EDM)
Consider the following statements with reference to Jet stream. 1. The Jet Stream is a geostrophic wind. 2. There are two permanent jet streams – subtropical jets at mid-latitudes and polar front jets at lower latitudes. 3. Temperature also influences the velocity of the jet stream. The lower the difference in air temperature, the faster the jet stream. Which of the statements given above is/are NOT correct?
Whenever some external system of forces acts on a body, it undergoes some deformation. As the body undergoes some deformation, it sets up some resistance to the deformation. This resistance per unit area to deformation, is called
In Abrasive jet machining, what may be the size of the abrasive grains used?
What is the value of abrasive grain flow rate in Abrasive jet machining?
What is the grain size of abrasive particles, which are often used for Abrasive water jet machining?
Abrasive flow value in Abrasive water jet machining will range between which of the following values?