Bissoy.com
Doctors Medicines MCQs Q&A

What is the only difference between Plasma arc welding and TIG welding?

What is the only difference between Plasma arc welding and TIG welding? Correct Answer Construction of torch is different

Construction of the torch is the only difference between Plasma arc welding and TIG welding. Both the TIG and PAW are uses tungsten electrodes.

Related Questions

Which of the following statement(s) is/are true regarding butt welding? 1. Flash butt welding is a combination of resistance, arc and pressure welding 2. Upset butt welding is used for welding rods 3. Percussion Welding is a self timing spot welding method 4. Aluminium alloys are flash welded
In DC arc welding, if leads are arranged in work as Negative pole of the welding arc and electrode as Positive pole of the welding arc, the arrangement is known as
In TIG arc welding, the welding zone is shielded by an atmosphere of
In welding magnesium with TIG arc welding, direct current with ________ is used.
In welding copper alloys with TIG arc welding
TIG welding of thin plates will give steeper thermal gradients than submerged arc welding of thick plates, the latter process will have the higher heat input.
Arrange the following stages in a sequence, such that they result in an ogee curve between two parallel lines AB and CD, such that they are the tangents to the arc. m) Join the adjacent ends B and C with a straight line. n) Divide the line BC into four parts using the points P1, P2, P3. o) Draw lines such that they pass through the points P1, P2, P3, and are perpendicular to the line BC. p) Draw the perpendicular lines through the points B and C such that they cut the lines passing through P1, P3 respectively at E and F. q) With the center E draw an arc BP2 and with center F draw an arc P2C, thus arc BP2C is required ogee curve.
Given are the steps to draw a tangent to given arc even if center is unknown and the point P lies on it. Arrange the steps. Let AB be the arc. i. Draw EF, the bisector of the arc CD. It will pass through P. ii. RS is the required tangent. iii. With P as center and any radius draw arcs cutting arc AB at C and D. iv. Draw a perpendicular RS to EF through P.
If a gas metal arc process uses a low arc voltage and the arc is continuously interrupted as the molten electrode metal fills up the arc gap is known as
A circular arc QTS is kept in an external magnetic field $${\overrightarrow {\bf{B}} _0}$$ as shown in figure. The arc carries a current $$l$$. The magnetic field is directed normal and into the page. The force acting on the arc is
Electromagnetic Theory mcq question image