Bissoy.com
Doctors Medicines MCQs Q&A

Chip flow velocity during machining process is 0.2m/s with chip thickness ratio of 0.6. What is the value of cutting velocity?

Chip flow velocity during machining process is 0.2m/s with chip thickness ratio of 0.6. What is the value of cutting velocity? Correct Answer 0.33m/s

Chip flow velocity= chip thickness ratio * cutting velocity. Hence cutting velocity = 0.33m/s.

Related Questions

Chip flow velocity during machining process is 1.2m/s with chip thickness ratio of 0.6. What is the value of cutting velocity?
If t1 denotes the uncut chip thickness and t2 denotes cut chip thickness ratio then, which of the following equation is correct about chip thickness ratio ‘r’?
Shear velocity during machining process is 0.2m/s with chip thickness ratio of 0.6. Shear angle is 30 degree and rake angle is 15 degree. What is the value of cutting velocity?
Shear velocity during the machining process is 1.2m/s with chip thickness ratio of 0.6. Shear angle is 30 degree and rake angle is 15 degree. What is the value of cutting velocity?
In an orthogonal cutting, the depth of cut is halved and the feed rate is double. If the chip thickness ratio is unaffected with the changed cutting conditions, the actual chip thickness will be
In an orthogonal machining operation : Uncut thickness = 0.5 mm Cutting speed = 20 m/min Rake angel = 150 Width of cut = 5 mm Chip thickness = 0.7 mm Thrust force = 200 N Cutting force = 1200 N The values of shear angle and shear strain, respectively, are
Arrange the processes in the increasing order of their maximum material removal rate. Electrochemical Machining (ECM) Ultrasonic Machining (USM) Electron Beam Machining (EBM) Laser Beam Machining (LBM) and Electric Discharge Machining (EDM)
Which of the following forces are measured directly by strain gauges or force dynamometers during metal cutting? 1. Force exerted by the tool on the chip acting normally to the tool face 2. Horizontal cutting force exerted by the tool on the workpiece 3. Frictional resistance of the tool against the chip flow acting along the tool face 4. Vertical force which helps in holding the tool in position Select the correct answer using the codes given below.
Thickness of 8 tyres L, M, N, O, P, Q, R and S is compared. Thickness of no two tyres is same. Thickness of N is more than L but less than 6 tyres. Thickness of O is more than M but less than Q. Thickness of P is less than only two tyres. Thickness of Q is not more than P. Which of the following statement is not correct?
A single-point cutting tool with 120C rake angle is used to machine a steel work-piece. The depth of cut, i.e., uncut thickness is 0.81 mm. The chip thickness under orthogonal machining condition is 1.8 mm. The shear angle is approximately