In pre-tensioning system, after curing and hardening of concrete the reinforcement is set ___________

In pre-tensioning system, after curing and hardening of concrete the reinforcement is set ___________ Correct Answer Fixed

In pre-tensioning system, the tendons are tensioned first and then the casting of concrete is carried out and the edge of the tendon at its either side is fixed to an abutment and its other edge is pulled with the application of jack and then the reinforcements are set free after curing and hardening.
Bissoy MCQ

Related Questions

The only suitable method for hardening the low carbon steel is case hardening. Which of the following is a case hardening process?
For the supply of materials for concrete, form work reinforcing and placing of concrete, removal of form work and curing of concrete, number of bar(s) required on bar chart, is
What maximum thickness of concrete can be poured without causing the temperature gradient to exceed 98.5 degree Celsius per meter anywhere in the slab? Consider a 1.2 m thick slab of poured concrete (k = 1.148 W/m degree) with both of side surfaces maintained at a temperature of 20 degree Celsius. During its curing, chemical energy is released at the rate of 80 W/m3. Workout the maximum temperature of concrete
The British code for structural concrete recommends design values of ultimate creep strain of pretensioning is ___________
If the main reinforcement of the slab is parallel to a T-beam, the transverse reinforcement at mid span of the slab is provided at least __________ of main reinforcement.
The tendons in the pretensioning system are tensioned between ___________
It is found that the _______ water does not lead to corrosion of reinforcement, provided the concrete is dense and there is enough cover to the reinforcement.
The final curing can be provided to the treated soil in the form of membrane curing.
Which of the following curing agent is used in the polymerization (curing) reaction to transform the liquid resin (diglycidyl ether of bisphenol A) to the solid state of epoxy polymer?
Over-curing or under-curing of the shell mould, leads to the generation of sophisticated problems in the shell mould.