Related Questions

Low quality of jute fibre is attributed to
1. Discoloration of fibre
2. Very short fibre strands
3. Reduction of cellulose in fibre
4. Reduction of cell wall strength over-retting decreases the fibre quality due to
Select the correct answer:
A glass fibre reinforced epoxy composite is made with 60 wt.% unidirectional continuous glass fibres. The elastic moduli of the glass fibre and the epoxy matrix are 72.5 and 2.4 GPa, respectively. What is the elastic modulus of this composite along the fibre direction, in GPa? The densities of glass fibre and epoxy are 2.58 g/cm3 and 1.14 g/cm3, respectively
Consider the following statements.
1. Fibre optics is based on the principle of total internal reflection.
2. In an optical fibre communication system, power consumption is extremely low
3. Optical fibre communications are free from radio frequency interference.
4. In India, Reliance Group of Industries is engaged in the manufacture of the optical fibre.
Which of these statements are correct?
From an alloy, two specimens are machined and tested separately under tension and compression. The engineering stress-strain curves as well as the true stress-true strain curves for tension and compression are plotted in the same diagram. Identify the correct statements:
P. The engineering stress-strain curves in tension and compression are identical.
Q. The true stress-true strain curve in compression is lower than the true stresstrue strain curve in tension due to Bauschinger effect.
R. The true stress-true strain curve in tension is above the corresponding engineering stress-strain, curve.
S. The true stress-true strain curve in tension and compression are identical.
If any cross section is subjected to direct tensile stress and bending stress, then find the dimension of cross section. Given length & breadth are t and 2t respectively. F=25kN acts on the top fibre of the cross section, M=F x t . Also maximum allowable tensile stress =100N/mm².
In a beam subjected to pure bending, the intensity of stress in any fibre is _________ the distance of the fibre from the neutral axis.
Which of the following stresses are associated with the tightening of a nut on a bolt? P. Crushing and shear stress in threads Q. Bending stress due to the bending of bolt R. Torsional shear stress due to frictional resistance between the nut and the bolt Select the correct answer using the codes given below:
Which of the following stresses are associated with the tightening of a nut on a bolt? P. Tensile stress due to the streching of bolt Q. Bending stress due to the bending of bolt R. Torsional shear stress due to frictional resistance between the nut and the bolt Select the correct answer using the codes given below.
The design stress, which is more than the damaging stress, is the least unit stress that will render a member unfit for service before the end of its normal life. The design stress factor or factor of safety indicates the margin between design stress and the __________ stress.
Tresca or maximum-shear stress criteria assumes that yielding occurs when the maximum shear stress reaches a value of the shear stress in the uniaxial tension test. Assume the principal stress being σ1, σ2, σ3 where σ1 is largest, and σ3 is the smallest principal stresses. Find the value of minimum shear stress to cause yielding, given that yield stress in tension is equal to σo?