Bissoy.com
Doctors Medicines MCQs Q&A

The transverse shear stress acting in a beam of rectangular cross-section, subjected to a transverse shear load, is ____________

The transverse shear stress acting in a beam of rectangular cross-section, subjected to a transverse shear load, is ____________ Correct Answer Variable with maximum on the neutral axis

Maximum value of shear stress at neutral axis is τ = 3/2 τmean So, transverse shear stress is variable with a maximum in the neutral axis.

Related Questions

Consider the following statements with regards to the shear force diagram for the beam ABCD: 1. The beam ABCD is an overhanging beam having supports at A and D only. 2. The beam carries a point load of 20 kN at C. 3. The beam carries a concentrated load of 10 kN at the end B. 4. The beam is an overhanging beam having supports at C and D only. 5. The beam carries a uniformly distributed load of 70 kN over the left hand portion AC only. Which of the above statements are correct?
In which of the following cases, there exists the situation of Pure Bending in some part of the beam or along the entire beam? i) A simply supported beam subjected to two equally spaced downward concentrated loads ii) A simply supported beam subjected to two equally spaced opposite moments iii) A cantilever beam subjected to clockwise moment at free end iv) An overhanging beam with both side overhangs subjected to different concentrated loads at both the free ends
Tresca or maximum-shear stress criteria assumes that yielding occurs when the maximum shear stress reaches a value of the shear stress in the uniaxial tension test. Assume the principal stress being σ1, σ2, σ3 where σ1 is largest, and σ3 is the smallest principal stresses. Find the value of minimum shear stress to cause yielding, given that yield stress in tension is equal to σo?
If a body is subjected to stresses in xy plane with stresses of 60N/mm² and 80N/mm² acting along x and y axes respectively. Also the shear stress acting is 20N/mm²Find the maximum amount of shear stress to which the body is subjected.
A body is subjected to a tensile stress of 1200 MPa on one plane and another tensile stress of 600 MPa on a plane at right angles to the former. It is also subjected to a shear stress of 400 MPa on the same planes. The maximum shear stress will be
Consider the following statements regarding types of supports and beams: 1. When both supports of beams are roller supports, the beam is known as simply supported beam. 2. A beam with one end fixed and the other end free is known as fixed beam. 3. A beam with both ends fixed is known as cantilever beam. 4. A beam with one end fixed and the other simply supported is known as propped cantilever. Which of the above statements is/are correct ?
If a body is subjected to stresses in xy plane with stresses of 60N/mm² and 80N/mm² acting along x and y axes respectively. Also the shear stress acting is 10N/mm². Find the inclination of the plane in which shear stress is maximal.
Consider the following statements: The basic reason why shafts are made of steel and its alloys is: 1. The shaft is subjected to normal stress. 2. The shaft stress alternates with respect to time. 3. The shaft is subjected to pure compressive stress. 4. The shaft is subjected to the stress of constant intensity. Which of these statements are correct?
A rectangular beam of 500 mm wide is subjected to maximum shear force of 250kN, the corresponding maximum shear stress been 3 N/mm2. The depth of the beam is equal to ______
A body is subjected to a tensile stress of 1200 MPa on one plane and another tensile stress of 600 MPa on a plane at right angles to the former. It is also subjected to a shear stress of 400 MPa on the same planes. The maximum normal stress will be