Bissoy.com
Doctors Medicines MCQs Q&A

Which of the following parameters control the quality of weld?

Which of the following parameters control the quality of weld? Correct Answer size of electrode

The parameters control the quality of weld are size of electrode and the current that produces sufficient heat to melt the base metal and minimizes electrode splatter.

Related Questions

Which of the following is/are the advantages of using a control chart for inspection? (i) A control chart indicates whether the process is in control or out of control. (ii) A control chart determines process variability. (iii) A control chart ensures product quality. (iv) Scrap or percentage reduction can be reduced by taking the necessary actions in time against the warnings indicated by control charts. (v) Control charts build up the reputation of the organization through customer’s satisfaction. (vi) The control chart can detect the unusual variations taking place in a process.
In the consumable electrode shielded metal arc welding process, which of the following observations are correct?
P. The, weld composition does not depend upon the basicity of the slag.
Q. Basic flux is used to achieve low hydrogen content-and low inclusion content in the weld metal.
R. Reverse polarity of the direct current power source is used to weld thin sheets.
S. Coated electrodes are classified by tensile strength of the weld metal deposit.
A 70 kg tea powder contains mixture from two qualities. Some amount of quality 1 tea powder is added so that ratio of quality 1 to quality 2 becomes 5 : 4. What is the extra amount of of quality 2 to be added so that, quality 2 becomes double the amount of quality 1 in new mixture. Given: current quality 1 exceeds quality 2 in old mixture by 10 kg?
A fillet-welded joint is subjected to transverse loading F as shown in the figure. Both legs of the fillets are of 10 mm size and the weld length is 30 mm. If the allowable shear stress of the weld is 94 MPa, considering the minimum throat area of the weld, the maximum allowable transverse load per weld in kN is
Which of the following characteristics should be possessed by a properly made weld? 1. The weld should not crack in the bend test 2. There should be no scum imbedded In the weld 3. Appearance should be spongy 4. Electrode distance variation should be minimal
The tensile strength of the welded joint for double fillet is (where s = Leg or size of the weld, $$l$$ = Length of weld and $${\sigma _{\text{t}}}$$ = Allowable tensile stress for weld metal)
Two plates of 12mm and 16mm thickness are to be joined by groove weld. The joint is subjected to factored tensile load of 400kN. Due to some reasons the effective length of weld that could be provided was 150mm only. What is the safety of joint if single-V groove weld is provided?
In butt weld joint, what will be the strength equation? if the thickness of the plate is t, permissible tensile stress for the weld is σt, and the length of the weld is l.
The permissible stress in the fillet weld is 100 N/mm². The fillet weld has equal leg lengths of 15 mm each. The allowable shearing load on the weldment per cm length of the weld is
Based on the given para, answer the following question. Sensitivity considerations often are important in the design of Control Systems. Because all physical elements have properties that change with environment and age, we cannot always consider the parameters of the Control System to be completely stationary over the entire operating life of the system. For instance, the winding resistance of an electric motor changes as the temperature of the motor rises during operation. Control systems with electric components may not operate normally when first turned on because of the still-changing system parameters during warmup. This phenomenon is sometimes called “morning sickness”. Most duplicating machines have a warmup period during which time operation is blocked out when first turn on. A good Control System should be: (a) Very sensitive to parameter variations (b) Insensitive to parameter variations (c) Insensitive to input commands (d) Sensitive to input commands Which of the above are correct?