Bissoy.com
Doctors Medicines MCQs Q&A

in most cases, for a given loading maximum stress and deflection of an indeterminate structure are __________ than that of a determinate one.

in most cases, for a given loading maximum stress and deflection of an indeterminate structure are __________ than that of a determinate one. Correct Answer Smaller

Indeterminate structure deflects lesser than a determinate one.

Related Questions

Muller-Breslau Principle for obtaining influence lines is applicable to 1. Statically determinate beams and frame 2. Statically indeterminate structures, the material of which is elastic and follows Hooke’s law 3.Any statically indeterminate structure 
Consider the following statements in connection with deflection-type and null-type instruments: 1. Null-type instruments are more accurate than the deflection-type ones. 2. Null-type of instrument can be highly sensitive compared to a deflection-type instrument. 3. Under dynamic conditions, null-type instruments are less preferred to deflection-type instruments. 4. Response is faster in null-type instruments as compared to deflection-type instruments. Which of the above statements are correct?
Muller Breslau’s principle for obtaining influence lines is applicable toi) trussesii) statically determinate beams and framesiii) statically indeterminate structures, the material of which is elastic and follows Hooke’s lawiv) any statically indeterminate structureThe correct answer is
From an alloy, two specimens are machined and tested separately under tension and compression. The engineering stress-strain curves as well as the true stress-true strain curves for tension and compression are plotted in the same diagram. Identify the correct statements:
P. The engineering stress-strain curves in tension and compression are identical.
Q. The true stress-true strain curve in compression is lower than the true stresstrue strain curve in tension due to Bauschinger effect.
R. The true stress-true strain curve in tension is above the corresponding engineering stress-strain, curve.
S. The true stress-true strain curve in tension and compression are identical.
Consider the following statements for deflection and null type instruments: 1. Deflection type of instruments are more accurate than null type of instruments. 2. Deflection type of instruments can be highly sensitive as compared with the null type of instruments. 3. Null type of instruments are more suitable for measurements under dynamic conditions than deflection type of instruments. Which of the above statements are not correct?
Tresca or maximum-shear stress criteria assumes that yielding occurs when the maximum shear stress reaches a value of the shear stress in the uniaxial tension test. Assume the principal stress being σ1, σ2, σ3 where σ1 is largest, and σ3 is the smallest principal stresses. Find the value of minimum shear stress to cause yielding, given that yield stress in tension is equal to σo?
To convert indeterminate structure to a determinate structure, number of force release to be provided equals to _______
A planar truss tower structure is shown in the figure. Consider the following statements about the external and internal determinacies of the truss. P. Externally determinate Q. External static indeterminacy = 1 R. External Static Indeterminacy = 2 S. Internally Determinate T. Internal Static Indeterminacy = 1 U. Internal Static Indeterminacy = 2 Which one of the following options is correct?
Indeterminate structures are economical than determinate structure.
The design stress, which is more than the damaging stress, is the least unit stress that will render a member unfit for service before the end of its normal life. The design stress factor or factor of safety indicates the margin between design stress and the __________ stress.