Bissoy.com
Doctors Medicines MCQs Q&A

Brick walls are measured in sq. m if the thickness of the wall is _________

Brick walls are measured in sq. m if the thickness of the wall is _________ Correct Answer 10 cm

10cm, actually in India half brick thick wall is 115 mm thick. Half brick Modular brick wall is 10cm. Thick including thickness of plaster. However plaster is paid separately in both the cases. In India half brick thick wall is paid in sq. meter.

Related Questions

Dipu wants to paint all the four walls of his room. All the walls are of rectangular shape and opposite walls are of same measurement. If the size of the walls are 4 m x 3.5 m and 4.5 m × 3.5 m and cost to paint the wall is Rs. 22 per square meter, what will be the total cost to paint the walls?
Thickness of 8 tyres L, M, N, O, P, Q, R and S is compared. Thickness of no two tyres is same. Thickness of N is more than L but less than 6 tyres. Thickness of O is more than M but less than Q. Thickness of P is less than only two tyres. Thickness of Q is not more than P. Which of the following statement is not correct?
I. All the offices on the 9th floor have wall-to-wall carpeting. II. No wall-to-wall carpeting is pink. III.None of the offices on the 9th floor has pink wall-to-wall carpeting. If the first two statements are true, the third statement is
If the first two statements are true, the third statement is :
I. All the offices on the 9th floor have wall-to-wall carpeting.
II. No wall-to-wall carpeting is pink.
III. None of the offices on the 9th floor has pink wall-to-wall carpeting.
Brick walls are measured in sq. m if the thickness of the wall is
Brick walls are measured in sq. m if the thickness of the wall is?
A furnace is made of a refractory brick wall of thickness 0.5 metre and thermal conductivity 0.7 W/m.°K For the same temperature drop and heat loss, this refractory wall can be replaced by a layer of diatomaceous earth of thermal conductivity 0.14 W/m.K and thickness __________ metre.
In some brick masonry walls, patches of whitish crystals were found on the exposed surfaces, also chipping and spalling of bricks took place from the same walls. Which among the following are the causes of these defects? 1. Settlement of foundation 2. Over-loading of the walls 3. Sulphate attack 4. Efflorescence
The method of moving each brick through a small horizontal distance before it is finally laid in any brick wall and pressing it by means of brick hammer, is known as
Load-bearing walls are defined as those walls which carry their own weight only whereas non-load bearing walls are defined as those walls which can carry superimposed loads in addition to their own weight.