Bissoy.com
Doctors Medicines MCQs Q&A

For a streamlined body to achieve low drag coefficient, the boundary layer must_________

For a streamlined body to achieve low drag coefficient, the boundary layer must_________ Correct Answer Be attached to the body

For a streamlined body to achieve low drag coefficient, the boundary layer must be attached to the surface of the body for a long time as possible. This causes the wake to be narrow.

Related Questions

The boundary layer thickness at a distance of l m from the leading edge of a flat plate, kept at zero angle of incidence to the flow direction, is O.l cm. The velocity outside the boundary layer is 25 ml sec. The boundary layer thickness at a distance of 4 m is (Assume that boundary layer is entirely laminar)
Some small cubes of same height 7 cm but variable length and width are put inside a large cuboid of height 21 cm. Length and width of cuboid is 32 cm and 24 cm, respectively. Small cubes are put such that cubes at the bottom most layer is of similar base area; second layer contains all the cubes of similar base area and third layer have all the cubes of similar base area. Which of the following statement(s) given below is / are TRUE? A: If side of each small cubes at bottom most layer is 8 cm, then maximum number of small cubes that can be put at bottom most layer is 12. B: If maximum of 48 cubes can be put at second layer, then side of each cube at second layer is 6 cm. C: If side of each small cubes at third layer is 1.6 cm, then maximum number of small cubes that can be put at third layer is 300.
The total drag is a sum of the skin drag and the pressure drag. Which among of the following options, states the correct formula for skin drag and pressure drag? (Here µ stands for dynamic viscosity of fluid, D stands for diameter of the sphere and U stands for velocity of flow of fluid.)
An aircraft with elliptic wing planform has parasite drag coefficient as 0.6. Lift coefficient of wing is 0.25 and aspect ratio is 7.5. If induced drag co-efficient is 0.0235 then, find total drag coefficient for the wing.
For a symmetrical airfoil drag coefficient at zero lift is 0.05 and induced drag coefficient is 0.0025. Find the total drag coefficient.
A wave is first reflected by a boundary P and then by a boundary Q without dissipating energy. If the boundary P is rigid and the boundary Q is non-rigid, then find the fraction of the amplitude of the reflected wave by boundary P to the reflected wave by boundary Q.
When the boundary moves the solute atoms migrate along with the boundary and exert a drag that reduces the boundary velocity. The magnitude of the drag will depend on ______
If my glider has lift coefficient at maximum lift to drag as 1.5 and induced drag factor K is 0.007 then, find parasite drag coefficient.
The nature of normal grain growth in the presence of a second phase deserves special consideration. The moving boundaries will be attached to the particles exert a pulling force on the boundary restricting its motion. Therefore if the boundary intersects the particle surface at 90° the particle will feel a pull of (2πrγcosΘ)*sinΘ. This will be counterbalanced by an equal and opposite force acting on the boundary. As the boundary moves over the particle surface Θ changes and the drag reaches a maximum value, this happens when Θ becomes______
Clay layer A with single drainage and coefficient of consolidation Cv takes 6 months to achieve 50% consolidation. The time taken by clay layer B of the same thickness with double drainage and coefficient of consolidation $$\frac{{{\text{Cv}}}}{2}$$ to achieve the same degree of consolidation is