Bissoy.com
Doctors Medicines MCQs Q&A

Choose the most feasible method for raising the power to be delivered at the reactive end. (i)Reducing the line reactance (ii)Raising the voltage level

Choose the most feasible method for raising the power to be delivered at the reactive end. (i)Reducing the line reactance (ii)Raising the voltage level Correct Answer (i)

Increasing the voltage level is not always economical and reducing the voltages at stations is easier.

Related Questions

Under the condition for 3 phase alternator, maximum active power output, the delivered reactive power output is ________ while under maximum reactive power output, the delivered reactive power is ________
If Xl is leakage reactance, Xf is reactance due to field winding, Xdw is reactance due to damper winding and Xa is armature winding reactance then reactance of synchronous generator in subtransient state is due to which of the following?
A single phase 50 hz, generator supplies an inductive load of 5 MW at a power factor of 0.8 lagging using OHTL over 20 km. The resistance and reactance are 0.39Ω and 3.96 Ω. The voltage at receiving station is maintained at 10 KV. The sending end voltage is 11.68 kV. The new sending end voltage at the half the voltage regulation is _____________
Referring to the bellow figure, determine the voltage level that the output will reach during the pulse.
Time Response of Reactive Circuits mcq question image
In a power system, which of the following is/are critical clearance time of a fault related to? 1. Transient reactance 2. Sub-transient reactance 3. Reactive power limit 4. Transient stability limit
A company paid Rs. 6,00,000 as bonus to its employees at different levels A, B and C. Each employee at level A receives one and half times of the amount that was paid to each employee at level B and each employee at level B was paid twice the amount paid to the employee at level C. If 50 employees were on level A, 75 on level B and 100 on level C, how much amount was paid to each employee of level A ?
A single phase 50 hz, generator supplies an inductive load of 5 MW at a power factor of 0.8 lagging using OHTL over 20 km. The resistance and reactance are 0.39Ω and 3.96 Ω. The voltage at receiving station is maintained at 10 KV. The sending end voltage is 11.68 kV. If the voltage regulation is reduced to 50%, then the receiving end current at this operation mode will be _____________
A single phase 50 hz, generator supplies an inductive load of 5 MW at a power factor of 0.8 lagging using OHTL over 20 km. The resistance and reactance are 0.39Ω and 3.96 Ω. The voltage at receiving station is maintained at 10 KV. The sending end voltage is 11.68 kV. If the voltage regulation is reduced to 50%, then the power factor at this operation mode will be _________________
A single phase 50 hz, generator supplies an inductive load of 5 MW at a power factor of 0.8 lagging using OHTL over 20 km. The resistance and reactance are 0.39Ω and 3.96 Ω. The voltage at receiving station is maintained at 10 KV. The sending end voltage is 11.68 kV. If the voltage regulation is reduced to 50%, then the power factor angle at this operation mode will be _____________
A single phase 50 hz, generator supplies an inductive load of 5 MW at a power factor of 0.8 lagging using OHTL over 20 km. The resistance and reactance are 0.39Ω and 3.96 Ω. The voltage at receiving station is maintained at 10 KV. The sending end voltage is 11.68 kV. If the voltage regulation is reduced to 50%, then the power factor at this operation mode will be ____________