Bissoy.com
Doctors Medicines MCQs Q&A

What is the total ampere conductors/pole (in SI) if 600 lap wound conductors carry 120A current through conductors (P=4)?

What is the total ampere conductors/pole (in SI) if 600 lap wound conductors carry 120A current through conductors (P=4)? Correct Answer 18000

Ampere-conductors/pole =ZIc/P= Zla/AP. Ampere conductors per pole is calculated by multiplying total no. of conductors with the current carried by them divided by the total no. of poles. Ampere-conductors/pole = 600*120/4 =18000.

Related Questions

What is the total ampere turns/pole (in AT/pole) if 600 lap wound conductors carry 120A current through conductors (P=4)?
Lightening conductors are used to protect building from lightning strikes. Which of the following statements is/are true about lightening conductors? 1) Lightening conductors create an electric field at its top that lightning strikes it preferentially 2) Lightning conductors reduce the effect of the strike by uniformly distributing the charge (current) over the surface of the building 3) Lightning conductors take all the charge (current) to deep down in the earth 4) Lightning conductors must be installed at a place taller than the building Select the correct answer using the code given below
For a four pole, 16 slot armature with two coil-side/slot having lap connected progressive winding has single turn coils. The same machine is then wave wound, the emf induced in the lap wound dc machine to that of wave wound will be ________
A 4-pole Dc wound machine is lap wound with 400 conductors. The pole shore is 20 cm long and average flux density over one-pole pitch is 0.4 T, the armature diameter being 30 cm. Here, motor is drawing 25 A current at 1500 rpm. What is the available torque (N-m) at shaft?
Calculate the number of conductors on each pole piece required in a compensating winding for a 6-pole lap-wound dc armature containing 286 conductors. The compensating winding carries full armature current. Assume ratio of pole arc/ pole pitch = 0.7.
A 4-pole Dc wound machine is lap wound with 400 conductors. The pole shore is 20 cm long and average flux density over one-pole pitch is 0.4 T, the armature diameter being 30 cm. What is the value of flux/pole?
A 4-pole Dc wound machine is lap wound with 400 conductors. The pole shore is 20 cm long and average flux density over one-pole pitch is 0.4 T, the armature diameter being 30 cm. What is the value of induced emf?
What is the total ampere turns per pole for 720 lap wounded conductors with carrying armature current equal to 625A in a 6-pole machine?
A 400-V, 1000-A, lap wound dc machine has 10 poles, 860 armature conductors. The number of conductors in the pole face to give full compensation if pole face covers 70% of pole span is?
In the question below are given two statements followed by three conclusions numbered I, II and III. You have to take the given statements to be true even if they seem to be at variance with commonly known facts. Read all the conclusions and then decide which of the given conclusions logically follows from the given statements disregarding commonly known facts. Statements: Some Harsh are Ampere Some Star are not Harsh Some Attackers are not Ampere Conclusions: I. Some Attackers are not Star II. A lot of Ampere is Harsh III. Some Attackers are Star