Bissoy.com
Doctors Medicines MCQs Q&A

The belt factor is defined as the ratio of __________

The belt factor is defined as the ratio of __________ Correct Answer phasor sum of coil EMFs to the arithmetic sum of coil EMFs

Belt factor or distribution factor or breadth factor = kd= phasor sum of coil EMFs/arithmetic sum of coil EMFs.

Related Questions

Consider the following statements regarding V-belt drive : 1. The groove angle of the sleeve is less than the belt section angle 2. The efficiency of a V-belt drive is higher than that of a flat belt drive 3. The groove angle is so made that the belt gets wedged in the groove  Which of the above statements are correct ? 
A bucket wheel excavator with 20 buckets of capacity 0.5 m3 each, rotates at 5 rev/min. The bucket fill factor is 80%. The excavator loads on to 1200 mm wide belt conveyor. The cross-section area (m2) of the material on the belt is 0.1B2, where B is the belt width in m. The minimum speed of the belt in m/s to avoid spillage of material is
The ratio of belt tensions $$\frac{{{{\text{p}}_1}}}{{{{\text{p}}_2}}}$$ considering centrifugal force in flat belt is given by where,
m = mass of belt per meter (kg/m)
v = belt velocity (m/s)
f = coefficient of friction
$$\alpha $$ = angle of wrap (radians)
When the belt is transmitting maximum power, the belt speed should be (Where, m = mass of belt per meter (kg/m) and Pmax = maximum permissible tension in belt (N))
The efficiency of flat belt drive is 35%. If all the parameters are same and flat belt is replaced by V belt, than the efficiency of V belt will be?
When the belt is transmitting maximum power, the belt speed should be
(Where, m = mass of belt per meter (kg/m) and Pmax = maximum permissible tension in belt (N))
Which of the following belts are associated with seismic activity?
1. Circum-Pacific Belt
2. Circum-Atlantic Belt
3. Mid-Continental Belt
4. Mid-Atlantic Belt
In a flat belt drive, if the slip between the driver and belt is 1%, between the belt and follower is 3% and driver and follower pulley diameters are equal, then velocity ratio of the drive will be
Consider the following statements about Equatorial Low Pressure Belt. 1. It lies between 10°N and 10°S latitudes. 2. This belt is characterized by extremely low pressure with calm conditions. 3. The corresponding latitudes of Equatorial Low Pressure belt are called horse latitudes. Which of the statements given above is/are correct:
For a flat open-belt drive, the belt speed is 880 m/min and the power transmitted is 22.5 kW. What is the difference between the tight side and slack side tensions of the belt drive?