Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Pseudo steady state is not truly steady state but for convenience is treated as steady state. The above statement for a process is
If the thermal conductivity of a wall material is independent of temperature, the steady state temperature distribution in the very large thin plane wall having steady, uniform surface temperature follows __________ law.
If the thermal conductivity of a wall material is independent of temperature, the steady state temperature distribution in the very large thin plane wall having steady, uniform surface tempeature follows __________ law.
Match List-I with List-II and select the correct answer using the code given below the Lists: List I (Low-Latitude Climate) List I (Characteristic) A. Wet Equatorial 1. Uniform temperatures, mean near 27°C  B. Monsoon and trade wind coastal 2. Marked temperature cycle with very high temperature before the rainy season C. Wet-dry tropical  3. Temperatures show an annual cycle with a high temperature in the high-Sun season Strong temperature cycle. with intense temperature during the high-Sun season  D. Dry tropical 4. Strong temperature cycle, with intense temperature during the high-Sun season
If the solubilities of different components (in a liquid-liquid extraction system) increase with rise in temperature, then the temperature above which they dissolve completely is known as the critical solution temperature (CST or consolute temperature). If solubilities increase with decrease in temperature, then CST is the temperature below which they dissolve completely. If a binary system has no critical solution temperature, it implies that
Consider the following statements 1. Value of transient stability limit will be lower than steady-state stability limit 2. Transient stability limit is the maximum flow of power through a particular point in the power system without loss of stability when large and sudden disturbances occur 3. Critical clearing angle is related to the steady-state stability limit Which of the above statement(s) is/are correct?
A particular control system yielded a steady state error of 0.20 for unit step input. A unit integrator is cascaded to this system and unit ramp input is applied to this modified system. What is the value of steady-state error for this modified system?
A metal sphere of surface area 0.0225 m2 is in an evacuated enclosure whose walls are held at a very low temperature. Electric current is passed through resistors embedded in the sphere causing electrical energy to be dissipated at the rate of 75 W. If the sphere surfaces temperature is measured to be 560 K, while in steady state, calculate emissivity of the sphere surface
To effect a bond between two metal plates, 2.5 cm and 15 cm thick, heat is uniformly applied through the thinner plate by a radiant heat source. The bonding must be held at 320 K for a short time. When the heat source is adjusted to have a steady value of 43.5 k W/m2, a thermocouple installed on the side of the thinner plate next to source indicates a temperature of 345 K. Calculate the temperature gradient for heat conduction through thinner plate. In the diagram, the upper plate is 2.5 cm thick while the lower is 15 cm thick.
In case of likelihood of presence of steady-state resonance problem, the thyristors in NGH-SSR Damping Scheme DO NOT conduct at all during steady state.