Bissoy.com
Doctors Medicines MCQs Q&A

A single phase full-converter using R load is a _________ quadrant converter and that using an RL load without FD is a __________ quadrant converter

A single phase full-converter using R load is a _________ quadrant converter and that using an RL load without FD is a __________ quadrant converter Correct Answer one, two

In R load both V and I are positive, in RL load the voltage can be negative but current is always positive.

Related Questions

Which of the following statements is/are correct with respect to a Scott-connected transformer? I. It can do 3-phase to 2-phase conversion II. It can do 2-phase to 3-phase conversion III. It can do 2-phase to 4-phase conversion IV. It can do 3-phase to 4-phase conversion
The network formed by resistors and capacitors for modifying the rate of change of gain and the phase shift is called a compensating network. Which of the following statements are not correct ? (A) The main purpose of a compensating network is to modify the performance of op-amp ciruit over the desired frequency range (B) There are two types of op-amps : internally compensated and externally compensated (C) 741 C is an externally compensated op-amp while 709 C is internally compensated op-amp (D) The phase lag and phase lead are most commonly used compensating networks in op-amps (E) Phase lag contributes a positive phase angle and phase lead a negative phase angle Choose the most appropriate answer from the options given below : 
In case of three-phase dual converter, one of the converter circuits is fired at an angle of 60°. For both the converter circuits to have equal average output voltage, what is the value of the firing angle for the other converter circuit?
A three-phase cylindrical rotor synchronous generator has a synchronous reactance Xs and a negligible armature resistance. The magnitude of per phase terminal voltage is VA and the magnitude of per phase induced emf is EA. Considering the following two statements, P and Q, P: For any three-phase balanced leading load connected across the terminals of this synchronous generator, VA is always more than EA Q: For any three-phase balanced lagging load connected across the terminals of this synchronous generator, VA is always less than EA Which of the following options is correct?
A single phase full converter has discontinues load current. The converter is supplying a dc shunt motor (R-L-E) load. When the current falls to zero the output voltage is
A single phase full converter has discontinues load current. The converter is supplying a DC shunt motor (R-L-E) load. When the current falls to zero
A 3-phase bridge converter is given a three-phase supply in the phase sequence R-Y-B. Let the neutral to R phase voltage be Vm sinωt. The first SCR (connected to R phase) is fired at an angle of 15°. What is the maximum value at the output terminals at this instant?
In the below given figure the converter 1 (to the right side) has firing angle = α1, converter 2 has firing angle = α2. For the dual converter to operate in the second quadrant.
In the below given figure, the converter 1 (to the right side) has firing angle = α1, converter 2 has firing angle = α2. For the dual converter to operate in the fourth quadrant.
A single-phase full converter bridge, is connected to a RLE load. The source has a rms voltage of 230 V and the average load current is 10 A. Find the firing angle for which the power flows from AC source to the DC load. Consider E = 120 V, R = 0.4 Ω.