Bissoy.com
Doctors Medicines MCQs Q&A

What is the full form of SPDT with respect to switches?

What is the full form of SPDT with respect to switches? Correct Answer Single pole double throw

The full form of SPDT is “Single pole double throw” with respect to switches. This type of switches has one input and two outputs. These switches are versatile in nature as it facilitates with two output terminal form a single input.

Related Questions

To configure the VLAN trunking protocol to communicate VLAN information between two switches, what two requirements must be met?
1. Each end of the trunk link must be set to the IEEE 802.1e encapsulation.
2. The VTP management domain name of both switches must be set the same.
3. All ports on both the switches must be set as access ports.
4. One of the two switches must be configured as a VTP server.
5. A rollover cable is required to connect the two switches together.
6. A router must be used to forward VTP traffic between VLANs.
A 3 - ϕ CSI used for the speed control of an induction motor is to be realized using MOSFET switches as shown below. Switches S1 to S6 are identical switches. The proper configuration for realizing switches S1 to S6 is
Why the switches used in weighted resistor DAC are of single pole double throw (SPDT) type?
Consider the following statements: 1. The voltage developed across the OFF switches of the half-bridge converter is the maximum dc-link voltage. 2. In the full-bridge converter, the voltage across the primary of the transformer is the dc link voltage. 3. The voltage developed across the OFF switches of the full-bridge converter is half the maximum dc-link voltage. Which of the above statements are correct?
When we compare the half bridge converter and full bridge converter 1. The maximum collector current of a full bridge is only double that of the half bridge 2. Full bridge uses 4-power switches instead of 2, as in the double bridge. 3. Output power of a full bridge is twice that of a half bridge with the same input voltage and current. When of the above statements are correct?
Which three statements are true about the operation of a full-duplex Ethernet network?
1. There are no collisions in full-duplex mode.
2. A dedicated switch port is required for each full-duplex node.
3. Ethernet hub ports are preconfigured for full-duplex mode.
4. In a full-duplex environment, the host network card must check for the availability of the network media before transmitting.
5. The host network card and the switch port must be capable of operating in full-duplex mode.
Consider the following statements in respect of slow sand filter and rapid sand filter: 1. The two filters differ in respect of the standards regarding the non-uniformity of the sand used in their filtering media. 2. The two filters do not differ in respect of the effective size of the sand used in them. 3. The two filters differ in respect of their respective under-drainage system. 4. The two filters differ in respect of their respective rate of filtration. Which of the above statements are correct? 
What is the full form of DPDT with respect to switches?
What is the full form of DIAC with respect to switches?
You have two switches connected together with two crossover cables for redundancy, and STP is disabled. Which of the following will happen between the switches?