Bissoy.com
Doctors Medicines MCQs Q&A

Why the switches used in weighted resistor DAC are of single pole double throw (SPDT) type?

Why the switches used in weighted resistor DAC are of single pole double throw (SPDT) type? Correct Answer To connect the resistance to either reference voltage or ground

SPDT are electronic switches controlled by a binary word. If the binary input to a switch is 1, it connects the resistance to the reference voltage and if the input is 0, the switch connects the resistor to ground.

Related Questions

To configure the VLAN trunking protocol to communicate VLAN information between two switches, what two requirements must be met?
1. Each end of the trunk link must be set to the IEEE 802.1e encapsulation.
2. The VTP management domain name of both switches must be set the same.
3. All ports on both the switches must be set as access ports.
4. One of the two switches must be configured as a VTP server.
5. A rollover cable is required to connect the two switches together.
6. A router must be used to forward VTP traffic between VLANs.
The smallest resistor in a 12 bit weighted resistor DAC is 2.5kΩ, what will be the largest resistor value?
A 3 - ϕ CSI used for the speed control of an induction motor is to be realized using MOSFET switches as shown below. Switches S1 to S6 are identical switches. The proper configuration for realizing switches S1 to S6 is
Which type of switches are not preferable for a simple weighted resistor DAC?
Two poles X and Y stand 3√2 m apart, such that the angle of elevation of the top of pole X as observed from the foot of pole Y is 30° and the angle of elevation of the top of pole Y as observed from the top of pole X is 60°. What is the angle of elevation of the top of pole Y from the foot of pole X?
An 80√3 m long electric pole is standing in a park. Another pole is to be placed in the park, such that the top of first pole makes an angle of 30° with the top of second pole and an angle of 45° with the foot of second pole. What is the height of second pole? [Use √3 = 1.732]
Hotel Aditya has 10 single AC rooms, 5 double AC rooms and 18 non AC rooms. The fixed monthly rent of hotel is 150,000. The per day maintenance cost is Rs. 100 for double AC room, Rs. 75 for single AC room and Rs. 40 for non AC room. The per day charges are Rs. 600 for double AC room, Rs. 400 for single AC room and Rs. 250 for non AC room. In April 2003, the occupancy rate of non AC room was 50%, 70% of single AC room and 40% of double AC rooms. Find the profit/loss % for that particular month.
CMOS inverter is used as SPDT switch in resistor DAC and is connected to the op-amp line. Find the output of CMOS, if the input applied is 1
The parallel combination of a 6.8 kΩ resistor and a 10 kΩ resistor is in series with the parallel combination of a 2.2 kΩ resistor and a 1 kΩ resistor. A 100 V source is connected across the circuit. The resistor(s) with the greatest voltage drop is (are)
Which of the following is true about weighted majority votes?
1. We want to give higher weights to better performing models
2. Inferior models can overrule the best model if collective weighted votes for inferior models is higher than best model
3. Voting is special case of weighted voting