Bissoy.com
Doctors Medicines MCQs Q&A

All load impedances can be matched to a transmission line using double stub matching.

All load impedances can be matched to a transmission line using double stub matching. Correct Answer true

When a smith chart is used for impedance matching, if the normalized load admittance yL were inside the g+jb circle, no value of stub susceptance b1 could ever bring the load point to intersect with the 1+jb circle; this forms a forbidden range of admittance that cannot be matched.

Related Questions

In series stub matching, if the normalized impedance at a point on the transmission line to be matched is 1+j1.33. Then the reactance of the series stub used for matching is:
If the normalized admittance at a point on a transmission line to be matched is 1+j1.47. Then the normalized susceptance of the stub used for shunt stub matching is:
The two adjustable parameters in single stub matching are distance‘d’ from the load to the stub position, and _________
If a load of 10Ω has to be matched to a transmission line of characteristic impedance of 50Ω, then the characteristic impedance of the matching section of the transmission line is:
In a double stub tuner circuit, the load is of _______ length from the first stub.
When a transmission line of characteristic impedance(50Ω) zₒ is matched to a load by a λ/4 transmission line of characteristic impedance 100Ω, then the transmission co efficient is:
Consider the following statement: 1. Initial load tests and routine load tests are carried out on test piles and working Piles, respectively. 2. In a pile load test, the allowable load can be taken equal to half the ultimate load at which the total settlement amounts to one-tenth of the pile diameter. 3. In a pile load test, the allowable load can be taken equal to two-thirds of the total toad which causes a plastic settlement of 6 mm. Which of the above statements are correct?
If a transmission line of zₒ=50Ω is matched using λ/4 transmission line of z₁=100Ω, then the transmission co efficient T₂ is:
If the transmission co-efficient T₁ of a transmission line is 1.333 and the characteristic impedance of the λ/4 transmission line used is 100Ω, then the characteristic impedance of the transmission line is:
If a λ/4 transmission line is 100Ω is used to match a transmission line to a load of 100Ω, then the characteristic impedance of the transmission line is: