Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

The handle of a saucepan, 30 cm long and 2 cm in diameter, is subjected to 100 degree Celsius temperature during a certain cooking operation. The average unit surface conductance over the handle surface is 7.35 W/m2 degree in the kitchen air at 24 degree Celsius. The cook is likely to grasp the last 10 cm of the handle and hence the temperature in this region should not exceed 38 degree Celsius. What should be the thermal conductivity of the handle material to accomplish it? The handle may be treated as a fin insulated at the tip
Consider the following components in a multi-stage R-C coupled amplifier: 1. Parasitic capacitance of transistor 2. Coupling capacitance 3. Stray capacitance 4. Wiring capacitance Which of the above components effectively control high frequencies?
In the following question below are given some statements followed by some conclusions base on those statements. Taking the given statements to be true even if they seem to be at variance from commonly known facts. Read all the conclusions and then decide which of the given conclusion logically follows the given statements. Statements: I. No cycle is handle. II. Some handle are tyre. Conclusions: I. No tyre is cycle. II. Some tyre are handle. III. Some cycle are handle.
Consider the following statement: 1. Initial load tests and routine load tests are carried out on test piles and working Piles, respectively. 2. In a pile load test, the allowable load can be taken equal to half the ultimate load at which the total settlement amounts to one-tenth of the pile diameter. 3. In a pile load test, the allowable load can be taken equal to two-thirds of the total toad which causes a plastic settlement of 6 mm. Which of the above statements are correct?
Two capacitors having capacitance value 4F, three capacitors having capacitance value 2F and 5 capacitors having capacitance value 1F are connected in parallel, calculate the equivalent capacitance.
Calculate ultimate moment and shear of effective span is 30m, live load is 9kn/m, dead load excluding self weight is 2kn/m, load factors for dead load is 1.4 for live load is 1.6 cube strength of concrete fcu is 50n/mm2 cube strength at transfer is fci is 35n/mm2, tensile strength of concrete Ec is 34kn/mm2 loss ratio ɳ is 0.85 and 8mm diameter high tensile strength fpu is 1500n/mm2 are available for use and the modulus of elasticity of high tensile wires is 200kn/mm2?
If CT is the transition capacitance, which of the following are true? 1) in forward bias, CT dominates 2) in reverse bias, CT dominates 3) in forward bias, diffusion capacitance dominates 4) in reverse bias, diffusion capacitance dominates
Consider the following statements for Euler’s equation to find the critical load of a column : 1. Critical load of a column is proportional to the flexural rigidity. 2. Critical load of a column depends upon yield stress. 3. Critical load of a column is inversely proportional to the length of the column. 4. Critical load of a column is inversely proportional to the square of the length of the column. Which of the above statements are correct?
In connection with inspection and testing of concrete structures as per IS 456:2000, while conducting load tests on flexural members, what is the load (L) and minimum duration of load application(T) on the structure? (Use notations as : DL : dead Load, IL : Imposed load)
What is the partial safety factor for dead load in combination of DL+LL+WL/EL for limit state of serviceability, where DL=Dead load, LL=imposed load , WL=wind load, EL=earthquake load ?