Bissoy.com
Doctors Medicines MCQs Q&A

In the given situation for n-channel JFET, we get drain-to-source current is 5mA. What is the current when VGS = – 6V?

In the given situation for n-channel JFET, we get drain-to-source current is 5mA. What is the current when VGS = – 6V? Correct Answer 0.125 A

IDS = IDSS(1-VGS/VP)2 When VGS = 0, IDSS = IDS = 5mA When VGS = -6V, IDS = 5mA(1 + 4)2 IDS = 5 x 25 = 125 mA.

Related Questions

We know ID =1/2 kn (VGS + vgs – Vt)2. Let the signal vgs be a sine wave with amplitude Vgs, and substitute vgs = Vgs sin ω t in Eq.(5.43). Using the trigonometric identity show that the ratio of the signal at frequency 2ω to that at frequency ω , expressed as a percentage (known as the second-harmonic distortion) is
Consider the following statements regarding n-channel JFET: 1. The maximum drain current IDSS occurs when gate-to-source voltage VGS = 0 V and drain-to-source voltage VDS ≥ |VP|. (VP is pinch-off voltage). 2. For gate-to-source voltage VGS less than the pinch-off level, the drain current is 0 A. 3. For all levels of VGS between 0 V and the pinch-off level, the current ID will range between IDSS and 0 A, respectively. which of the above statements are correct ?
Consider the following statements regarding JFET: 1. The relationship between the drain current and gate-to-source voltage of a JFET is a nonlinear. 2. The minimum current for JFET occurs at pinch-off voltage defined by VGS = VP. 3. A current controlled device is one in which a current defines the operating conditions of the device. Which of the above statements are correct?
For a p-channel FET, the current ID at Vgs = 2V and Vds = 5V and Vgs = 3V was found to be 2mA, what will be the value of ID at Vgs = 0V and Vds = 5V?
The drain current of a MOSFET in saturation is given by ID=K(VGS-VP) (VGS-VP) where k is a constant. Determine the magnitude of gm.
The following statements refer to an n channel FET operated in the active region: 1. The gate voltage VGS reverse biases the junction 2. The drain voltage VDD is negative with respect to the source 3. The current in the n channel is due to electrons 4. Increasing the reveres bias VGS increases the cross section for conduction Which of these statements are correct?
For an n-channel FET, the current v at Vgs=-2V and Vds=5V was found to be 2mA, what will be the value of ID at Vgs=0V and Vds=5V?
A certain D-MOSFET is biased at VGS = 0 V. Its data sheet specifies IDSS = 20mA and VGS(off) = -5 V. The value of the drain current is ___________
Assertion (A): A JFET can be used as a current source.Reason (R): In beyond pinch off region the current in JFET is nearly constant.
Assertion (A): A JFET can be used as a current source.
Reason (R): In beyond pinch off region the current in JFET is nearly constant.