Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Which of the following is/are the advantages of using a control chart for inspection? (i) A control chart indicates whether the process is in control or out of control. (ii) A control chart determines process variability. (iii) A control chart ensures product quality. (iv) Scrap or percentage reduction can be reduced by taking the necessary actions in time against the warnings indicated by control charts. (v) Control charts build up the reputation of the organization through customer’s satisfaction. (vi) The control chart can detect the unusual variations taking place in a process.
Transient stability of the generator is dependent on (a) generator reactance; lower reactance decreases peak power and increases initial rotor angle. (b) how heavily the generator is loaded. (c) generator inertia; higher the inertia, slower the rate of the change of angle. (d) generator output during fault Which of the above is incorrect?
In a turbopump system using a gas generator cycle, the flame temperature in the separate gas generator where a small portion of overall propellant is burned is _________ compared to the main gas generator and its mixture ratio is _________ compared to that of the main gas generator.
Which one of the following is NOT correct according to the Consumer Protection Act?  1. District Forum shall consist of a lady social worker 2. State Commission shall consist of a person who is or has been a Judge of a High Court 3. District Forum shall consist of four members 4. National Consumer Disputes Redressal Commission shall consist of a person who is or has been a Judge of the Supreme Court 
An electric power generating station supplies power to three loads A, B, and C. Only a single generator is required when anyone load is switched on. When more than one load is on, an auxiliary generator must be started. The Boolean equation for the control of switching of the auxiliary generator will be
What is/are the advantages of using microprogramming as compared to hardwired method in implementation of control unit?
Consider the following processor design characteristics. I. Register-to-register arithmetic operations only II. Fixed-length instruction format III. Hardwired control unit Which of the characteristics above are used in the design of a RISC processor?
Which is the simplest method of implementing hardwired control unit?
Two friends X and Y purchased a generator for Rs. 2,00,000. They sold it after 5 months wherein X received a profit of Rs. 25,000. X and Y made profit in a ratio of 2 : 3 in the generator. Calculate the selling price of a generator.
A three-phase cylindrical rotor synchronous generator has a synchronous reactance Xs and a negligible armature resistance. The magnitude of per phase terminal voltage is VA and the magnitude of per phase induced emf is EA. Considering the following two statements, P and Q, P: For any three-phase balanced leading load connected across the terminals of this synchronous generator, VA is always more than EA Q: For any three-phase balanced lagging load connected across the terminals of this synchronous generator, VA is always less than EA Which of the following options is correct?