Bissoy.com
Doctors Medicines MCQs Q&A

A three phase 50 Hz transmission line has flat horizontal spacing with 3.5 m between adjacent conductors. The conductors are No. 2/0 hard drawn copper (outside diameter = 1.05cm). The voltage f the line is 110 kV. The line charging current per km of the line is _______________

A three phase 50 Hz transmission line has flat horizontal spacing with 3.5 m between adjacent conductors. The conductors are No. 2/0 hard drawn copper (outside diameter = 1.05cm). The voltage f the line is 110 kV. The line charging current per km of the line is _______________ Correct Answer 0.17 A/km

n:

Related Questions

A three phase 50 Hz transmission line has flat horizontal spacing with 3.5 m between adjacent conductors. The conductors are No. 2/0 hard drawn copper (outside diameter = 1.05cm). The voltage f the line is 110 kV. The line charging current per conductor of the line is _____________
A three phase 50 Hz transmission line has flat horizontal spacing with 3.5 m between adjacent conductors. The conductors are No. 2/0 hard drawn copper (outside diameter = 1.05cm). The voltage f the line is 110 kV. The capacitance to neutral per kilometre of line is
A three phase 50 Hz transmission line has flat horizontal spacing with 3.5 m between adjacent conductors. The conductors are No. 2/0 hard drawn copper (outside diameter = 1.05cm). The voltage f the line is 110 kV. The capacitive reactance to neutral per kilometre of line is ____________
A three phase 50 Hz transmission line has flat horizontal spacing with 3.5 m between adjacent conductors. The conductors are No. 2/0 hard drawn copper (outside diameter = 1.05cm). The voltage f the line is 110 kV. The reactive volt amperes generated by the line is
When an electric current coil of a wattmeter is connected to the electric current path R and the voltage coil is connected between the electric current R path and the neutral side of the balanced three phase supply, it shows 10 kW. The line voltage along the phase sequence RYB is 400 V. The current drawn by the current path is 54 A. What is the new reading of the wattmeter if the voltage coil is connected between the lines B and the Y paths, even if the electric current coil is continuously present in the line R?
Lightening conductors are used to protect building from lightning strikes. Which of the following statements is/are true about lightening conductors? 1) Lightening conductors create an electric field at its top that lightning strikes it preferentially 2) Lightning conductors reduce the effect of the strike by uniformly distributing the charge (current) over the surface of the building 3) Lightning conductors take all the charge (current) to deep down in the earth 4) Lightning conductors must be installed at a place taller than the building Select the correct answer using the code given below
Six flats A, B, C, D, E and F are located in two rows of three flats each. The flats in both the rows face each other. Flat D is diagonally opposite to flat C. Flat E is opposite to flat F, which is north facing. Flat C is 2nd to the left of A and both of flats are south facing. Which of the following flats is facing flat B?
All the forms of matter except gases emit electromagnetic radiation continuously. The gases which electrically or thermally excited emit a certain wavelength only, then which of the following is/are true about the process (i) The spacing between the atoms in the other forms of matter is high than in gas (ii) The spacing between the atoms in gases is high than the other forms of matter (iii) The energy of the emitted radiation depends on the spacing between the atoms (iv) The wavelength of the emitted radiation depends on the spacing between the atoms 
A semicircular disc rests on a horizontal surface with its top flat surface horizontal and circular portion touching down. The coefficient of friction between semi circular disc and horizontal surface is µ. This disc is to be pulled by a horizontal force applied at one edge and it always remains horizontal. When the disc is about to start moving, its top horizontal force will
A semi-circular disc rests on a horizontal surface with its top flat surface horizontal and circular portion touching down. The coefficient of friction between semi-cricular disc and horizontal surface is i. This disc is to be pulled by a horizontal force applied at one edge and it always remains horizontal. When the disc is about to start moving, its top horizontal force will