Bissoy.com
Doctors Medicines MCQs Q&A

Which of the following can be considered to be an advantage of FET amplifier as compared to BJT amplifier? A – Higher input impedance B – Good bias stability C – Higher gain-bandwidth product D – Lower noise figure Select the correct answer using the codes given below Codes:

Which of the following can be considered to be an advantage of FET amplifier as compared to BJT amplifier? A – Higher input impedance B – Good bias stability C – Higher gain-bandwidth product D – Lower noise figure Select the correct answer using the codes given below Codes: Correct Answer A, B and D

Advantage of FET over BJT are i) Higher input impedance ii) Good bias stability iii) Lower noise figure.

Related Questions

Choose the correct statement(s) i) The gate circuit impedance of MOSFET is higher than that of a BJT ii) The gate circuit impedance of MOSFET is lower than that of a BJT iii) The MOSFET has higher switching losses than that of a BJT iv) The MOSFET has lower switching losses than that of a BJT
Consider the following statements (a) BJT is a current controlled device with high input impedance and high gain band width (b) FET is a voltage- controlled device with high input impedance and low gain bandwidth (c) UJT is a negative resistance device and can be used as an oscillator (d) FET and UJT can be used for amplification Which of the above statements are correct 
Consider the following statements. 1. BJT is a current controlled device whereas IGBT is a voltage-controlled device. 2. BJT and IGBT have low input impedance whereas PMOSFET has higher input impedance. 3. IGBTs are available at higher voltage ratings than PMOSFETs because of increment in ON state voltage drop is less in IGBT. 4. IGBT and PMOSFETs have different substrate structures. The correct statements are
Which of the following are the basic differences between vibration signature and noise signature? 1. Vibration signature is essentially in the frequency range zero to 100 cps whereas noise signature is in the range 20 cps to 3000 cps. 2. Vibration signature has well-defined peaks whereas the noise signal is smeared. 3. The intensities of noise signatures arc much less than that of vibration signatures. 4. Detection of vibration signature calls for a microphone whereas that of noise can do with a pickup. Select the correct answer using the code given below.
Consider the following statements 1. Value of transient stability limit will be lower than steady-state stability limit 2. Transient stability limit is the maximum flow of power through a particular point in the power system without loss of stability when large and sudden disturbances occur 3. Critical clearing angle is related to the steady-state stability limit Which of the above statement(s) is/are correct?
Consider the circuit shown below which reduces the impact of the input bias current. If IB1 = IB2 = Input bias current, then determine the value of R3 so that the output voltage (v0) is not impacted by the input bias current.
A map shows the elevations of Darjeeling, Gangtok, Kalimpong, Pelling, and Siliguri. Kalimpong is at a lower elevation than Gangtok, Pelling is at a lower elevation than Gangtok. Pelling is at a higher elevation than Siliguri. Darjeeling is at a higher elevation than Gangtok. Which of the following statements can be inferred from the paragraph above? i. Pelling is at a higher elevation than Kalimpong ii. Kalimpong is at a lower elevation than Darjeeling iii. Kalimpong is at a higher elevation than Siliguri iv. Siliguri is at a lower elevation than Gangtok
A mixer stage has a noise figure of 20 dB. This mixer stage is preceded by an amplifier which has a noise figure of 9 dB and an available power gain of 15 dB. The overall noise figure referred to the input is
Below a question is given with one passage and its effects (I) and (II). One of these effects or both or none may be the effect of the statement. Read both the effect and decide which of the following answer choice correctly depicts the relationship between these cause and effect. Passage: In the urban area there exist a lot of industries, commercial places and public places religious places which involve a lot of a  people and working machinery note of sound and when this sound becomes unpleasant it is known as noise. it is one of the reasons why public authorities have divided the city into a number of zones is known as a different noise level. Effects: I        Noise leads to emotional and behavioural stress. A person may feel disturbed in the presence of loud noise such as produced by heating of drums. II       Noise may cause damage to the liver, brain, and heart.  
Which of the following statement is true about FET common source amplifier compared to BJT amplifier?