Bissoy.com
Doctors Medicines MCQs Q&A

Comparing the size of BJT and FET, choose the correct statement?

Comparing the size of BJT and FET, choose the correct statement? Correct Answer BJT is larger than the FET

BJT usually are built with a thickness of up to 1cm whereas the FET uses a fabrication technique which makes its size in mm.

Related Questions

Choose the correct statement(s) i) The gate circuit impedance of MOSFET is higher than that of a BJT ii) The gate circuit impedance of MOSFET is lower than that of a BJT iii) The MOSFET has higher switching losses than that of a BJT iv) The MOSFET has lower switching losses than that of a BJT
Consider the following statements (a) BJT is a current controlled device with high input impedance and high gain band width (b) FET is a voltage- controlled device with high input impedance and low gain bandwidth (c) UJT is a negative resistance device and can be used as an oscillator (d) FET and UJT can be used for amplification Which of the above statements are correct 
Which of the following statements are true with regards to the selection of a sample size? (i) The sample size (n) may be a fixed percentage of lot size (N). (ii) The sample size (n) may be kept constant irrespective of lot size (N). (iii) Sample size (n) can be selected at the personal whim of the inspector.
Consider the following statements regarding limits and fits 1. Actual size is the standard size for the part and is the same both for the hole and its shaft. 2: Basic size is the dimension as measured on the manufactured part. 3. Deviation is the algebraic difference between a size and the corresponding basic size. Which of the above statements is/are correct ? 
Consider the following statements regarding a differential amplifier using an FET pair. The differential output offset voltage is due to: 1. Mismatch between FET parameters 2. Difference between the values of resistors used in the circuit even though they are marked nominally equal 3. Variation in the operating voltage of the circuit Which of the above statements are correct?
Which of the following statement is true about FET common source amplifier compared to BJT amplifier?
Which of the following can be considered to be an advantage of FET amplifier as compared to BJT amplifier? A – Higher input impedance B – Good bias stability C – Higher gain-bandwidth product D – Lower noise figure Select the correct answer using the codes given below Codes:
Consider the following statements. 1. BJT is a current controlled device whereas IGBT is a voltage-controlled device. 2. BJT and IGBT have low input impedance whereas PMOSFET has higher input impedance. 3. IGBTs are available at higher voltage ratings than PMOSFETs because of increment in ON state voltage drop is less in IGBT. 4. IGBT and PMOSFETs have different substrate structures. The correct statements are
Thermal runaway is not possible in FET because as the temperature of FET increases
How does a FET behave when the v-I characteristics are to the left of pinch off for an n channel FET?