Bissoy.com
Doctors Medicines MCQs Q&A

How is the winding arrangement and how is the conductors in each slot?

How is the winding arrangement and how is the conductors in each slot? Correct Answer concentric winding and different conductor in each slot

The winding of the induction motors are concentric type. The different conductors are being used in each slot.

Related Questions

Five theatres PVR, DT, Chanakya, Regal and Maratha Mandir screen two out of ten films based on Romance, Thriller, Horror, Adventure, Children, Drama, Documentary, History, Religion and Cartoon. Each theatre exhibits only two films and allots two different slots for them, wherein slot I is before slot II. Chanakya screens a Horror film in the first slot, while Maratha Mandir exhibits a Historical film in the second slot. DT exhibits a thriller film in the second slot and Regal exhibits a documentary film. Drama must be exhibited only in the second slot. The children’s film and the Cartoon film are exhibited in the same theatre while the religious film is not in the first slot. If Chanakya screens a Religious film in its second slot, then which of the films can be screened by theatre Regal?
Lightening conductors are used to protect building from lightning strikes. Which of the following statements is/are true about lightening conductors? 1) Lightening conductors create an electric field at its top that lightning strikes it preferentially 2) Lightning conductors reduce the effect of the strike by uniformly distributing the charge (current) over the surface of the building 3) Lightning conductors take all the charge (current) to deep down in the earth 4) Lightning conductors must be installed at a place taller than the building Select the correct answer using the code given below
Distributed winding is a type of winding in electrical machines where all the winding turns are arranged in a number of full pitches or fractional pitches. These coils are then placed in phase form or the commutator winding in slots spread around the periphery of the air gap. This type of winding used in
For a four pole, 16 slot armature with two coil-side/slot having wave connected progressive winding has single turn coils has simplex winding. The number of current paths is?
What is the value of Yf for a lap winding with a 4-pole, 12-slot armature with two coil sides/slot? (Assume single-turns coils – progressive winding)
A 3-phase, 4-pole alternator has 48 stator slots carrying a 3-phase distributed winding. Each coil of the winding is short chorded by one slot pitch. The winding factor is given by ______________
Calculate the number of conductors on each pole piece required in a compensating winding for a 6-pole lap-wound dc armature containing 286 conductors. The compensating winding carries full armature current. Assume ratio of pole arc/ pole pitch = 0.7.
Arrange the following activities with regard to rehabilitation in industries.
1. Assessment of feasibility
2. Assessment of additional funds
3. Preparation of cash flow statements
4. Arrangement of funds with other creditors
5. Marketing arrangement
6. Arrangement for disposal of unwanted assets and recovery of over due debts
7. Arrangement with various financial institutions
8. Arrangement fir Management Performance
XYZ Limited is a small organization of eight employees. In order to ensure that there are no service interruptions, the HR department has prepared a lunch program for 'P, Q, R, S, T, U, V and W employees. From 1.00 am to 1.30 pm and from 1.30 pm to 2.00 pm there are only two scheduled times (slots) and the following conditions: a) Due to limited space to dine, the designated space (slot) can accommodate a maximum of five and a minimum of four employees. b) 'P' and 'S' will eat together. 'W' is not in that scheduled time (slot). c) 'Q' and 'R' cannot have lunch at the same time as 'S'. d) 'U' cannot have lunch with 'V' but with 'P' and 'T'. If V and W are having lunch at the scheduled time (slot) of 1.30 pm then who are the other people at the dinner table?
Recently, the USA decided to support India's membership in multilateral export control regimes called the "Australia Group" and the "Wassenaar Arrangement". What is the difference between them? 1. The Australia Group is an informal arrangement which aims to allow exporting countries to minimize the risk of assisting chemical and biological weapons proliferation, whereas the Wassenaar Arrangement is a formal group under the OECD holding identical objectives. 2. The Australia Group comprises predominantly of Asian, African and North American countries, whereas the member countries of Wassenaar Arrangement are predominantly from the European Union and American continents. Which of the statements given above is/are correct?