Bissoy.com
Doctors Medicines MCQs Q&A

Guess the saturated molar absolute humidity of the gas(A.- Vapour(B. mixture at 100 degree Celsius. Vapour pressure of A is 300 mmHg and the total pressure is 760 mmHg.

Guess the saturated molar absolute humidity of the gas(A.- Vapour(B. mixture at 100 degree Celsius. Vapour pressure of A is 300 mmHg and the total pressure is 760 mmHg. Correct Answer 0.65

Saturated molar humidity= Vapour pressure of A/ Vapour pressure of B = 300/(760-300) =0.65.

Related Questions

Different air pressures were observed in adjacent areas A and B   Area A Area B Time 10 A.M. 733 mmHg 723 mHg Time 12 P.M 800 mmHg 600 mmHg Time 02 P.M. 800 mmHg 700 mmHg Time 04 P.M. 950mmHg 850 mmHg At what time of the day, the speed of wind will be fastest?
Check whether we get approximately 80% saturation if the total pressure and the partial pressure of the gas mixture is 760 mmHg and 260 mmHg. Also, the vapour pressure is 300 mmHg.
Consider the following statements and choose the correct answer:
1. A direct proportionality exists between vapour pressure and the concentration of water vapour in the atmosphere
2. Relative humidity is an expression of the ratio of the actual vapour pressure of the atmosphere when saturated at the same temperature
3. A rise or fall in temperature with no change in vapour pressure will cause a drop or rise, respectively, in relative humidity
4. A rise or fall in vapour pressure with no change in temperature will be accompanied by a rise or fall, respectively, in relative humidity
Consider a saturated gas(A.-vapour(B. mixture , if the absolute molal humidity is 0.265 and the total pressure= 760 mmHg. Find the vapour pressure of B.
The total pressure of water vapour, nitrogen and hydrogen is 864 mmHg. The partial pressure of nitrogen is 410 mmHg and that of hydrogen is 220 mmHg. What is the partial pressure of water vapour?
Consider the following statements: 1. There is no change in temperature when a liquid is being evaporated into vapour 2. Vapour is a mixed phase of liquid and gas in the zone between saturated liquid line and saturated vapour line 3. The saturated dry vapour curve is steeper as compared to saturated liquid curve on a T-s diagram 4. The enthalpy of vaporization decreases with increase in pressure Which of the above statements are correct?
Consider an ideal vapour-liquid binary mixture, find the total pressure if the vapour pressure of A is 260 mmHg and the vapour pressure of B is 520 mmHg and the composition of A in mole fraction is 0.55.
In a surface condenser, the water flowing through a series of tubes at the rate of 200 kg/hr is heated from 15 degree Celsius to 75 degree Celsius. The steam condenses on the outside surface of tubes at atmospheric pressure and the overall heat transfer coefficient is estimated at 860 k J/m2 hr degree. Find the effectiveness of the heat exchanger. At the condensing pressure, stream has a saturation temperature 0f 100 degree Celsius and the latent heat of vaporization is 2160 k J/kg. Further, the steam is initially just saturated and the condensate leaves the exchanger without sub-cooling i.e. only latent heat of condensing steam is transferred to the water. Take specific heat of water as 4 k J/kg K
In a surface condenser, the water flowing through a series of tubes at the rate of 200 kg/hr is heated from 15 degree Celsius to 75 degree Celsius. The steam condenses on the outside surface of tubes at atmospheric pressure and the overall heat transfer coefficient is estimated at 860 k J/m2 hr degree. Find the number of transfer units of the heat exchanger. At the condensing pressure, stream has saturation temperature 0f 100 degree Celsius and the latent heat of vaporization is 2160 k J/kg. Further, the steam is initially just saturated and the condensate leaves the exchanger without sub-cooling i.e. only latent heat of condensing steam is transferred to water. Take specific heat of water as 4 k J/kg K
The rear window of an automobile is made of thick glass i.e. AB = 5 mm and thermal conductivity is 0.8 W/m degree. To defrost this window, a thin transparent film type heating element has been fixed to its inner surface. For the conditions given below, determine the electric power that must be provided per unit area of window if a temperature 5 degree Celsius is maintained at its outer surface. Interior air temperature and the corresponding surface coefficient are 20 degree Celsius and 12 W/m2 degree. Surrounding air temperature and the corresponding surface coefficient are – 15 degree Celsius and 70 W/m2 degree. Electric heater provides uniform heat flux