Related Questions

The mitral valve
A Possesses two cusps
B Is closely related to the aortic valve
C Guards the right atrioventricular orifice
D Has no papillary muscle attachments
E Lies on the posterior wall of the left ventricle
Aortic regurgitation may occur in
A Reiter's syndrome [Davidson's/23rd/P-1031(see C/]
B Ankylosing spondylitis
C Polymyalgia rheumatica
D Systemic lupus erythematosus
E Polymyositis
For the same terminal conditions and valve size, the pressure drop in a fully opened globe valve as compared to that in a gate valve is
A More
B Less
C Equal
D Either A or B; depends on the viscosity of the fluid
The following features are present in mitral stenosis
A Left atrial thrombus may be present
B Atrial fibrillation is a feature
C Mitral valve narrowing less than 2cm
D Causes left to right shunt
E Causes high volume pulse
The mixing vat in a factory receives liquid ingredients through six separate value--- labeled R.S.T.U,Y and Z -- each of which has exactly two settings: open and closed.The mixing vat operator must ensure that each valve is set open or closed according to the following conditions: If T is open, both S and Z must be closed, R and Z cannot both be closed at the same time; If Y is closed, Z must also be closed;S and U cannot both be open at the same time. Which of the following, if given to the mixing vat operator as an instruction, would not determine the setting of any other valve ?
A S must be open
B T must be open
C U must be open
Main gas valve in a gaseous fuel burner is a __________ valve.
A Gate
B Butterfly
C Globe
D None of these
In Meyer's expansion valve, the expansion valve is driven by an eccentric having an angle of advance from
A 50° - 60°
B 60° - 70°
C 70° - 80°
D 80° - 90°
In Meyer's expansion valve, the main valve is driven by an eccentric having an angle of advance from
A 10° - 15°
B 15° - 25°
C 25° - 30°
D 30° - 40°
In a steam engine, the earlier cut-off with a simple slide valve may be obtained by increasing the steam lap and the angle of advance of the eccentric but keeping constant the travel and lead of the valve, this method will
A Cause withdrawing or throttling of steam
B Reduce length of effective stroke of piston
C Reduce maximum opening of port to steam
D All of these
The size of inlet valve of an engine in comparison to exhaust valve is
A More
B Less
C Same
D More/less depending on capacity of engine

Next steps