Related Questions

When two computers communicate with each other, they send information back and forth. If they are separated by a reasonable distance, they can send and receive the information through a direct cable connection which is called a null-modem connection. Presently what is the maximum distance in metres permitted in this null-modem connection?
A 80
B 100
C 30
D 150
E None of the above
Which of the following is not the value the key property will hold if the key is a function key?
A F8
B F2
C F9
D Left
When assigning a shortcut key to a symbol, you should always try to select a key or key combination that is:
A Unassigned
B Located on the ten-key pad section of your keyboard.
C Assigned to another task.
D From the same font family as the symbol.
A taper key which fits half in the key way of the hub and half in the key way of shaft, is known as
A sunk key
B flat saddle key
C hollow saddle key
D tangent key
When the material of key and shaft is same, and the width of key is one-fourth of the diameter of shaft (d), then length of key will be
A 0.8 d
B 1.2 d
C 1.57 d
D 1.8 d
You need to configure a router for a Frame Relay connection to a non-Cisco router. Which of the following commands will prepare the WAN interface of the router for this connection?
A Router (config-if) #encapsulation frame-relay q933a
B Router (config - if) #encapsulation frame-relay ansi
C Router (config - if) #encapsulation frame-relay ietf
D Router (config - if) #encapsulation frame-relay cisco
If Q is load factor, S is shape factor and F is factor of safety in elastic design, the following:
A Q = S + F
B Q = S - F
C Q = F - S
D Q = S × F
Factor of safety (i.e., overdesign factor) in heat transfer equipments is about __________ percent more than the actual/theoretical design factor.
A 5-10
B 15-20
C 30-35
D 35-40
বুদ্ধির ক্ষেত্রে চালর্স স্পিয়ারম্যান কোন কোন ধরনের সামর্থ্যের কথা উল্লেখ করেছেন? i. e-factor ii. g-factor iii. s-factor নিচের কোনটি সঠিক?
A i ও ii
B i ও iii
C ii ও iii
D i, ii ও iii
How many keys are available in the Numerical Key Pad of a standard Key-board ?
A 20
B 15
C 17
D 13

Next steps