How thick of a piece of wood is recommended for doing relief-type carvings with a dremel and flexshaft?

Question

How thick of a piece of wood is recommended for doing relief-type carvings with a dremel and flexshaft?

Md Ariful Islam

বিএসসি(সিএসই) , এমবিএ(মার্কেটিং)

সফটওয়্যার ইঞ্জিনিয়ার Bissoy.com

4 views

2025-01-04 04:42

1 Answers

Related Questions

I would like to delete more than one piece of mail without doing it one by one from my phone, what do I do?

1 Answers 4 Views

What type of wood should be used for a futon-style bed?

1 Answers 4 Views

How thick does the wood for the body need to be?

1 Answers 4 Views

What type of stain is good for wood exterior doors and should I use a primer before staining?

1 Answers 4 Views

We are ready to install two basement windows. There is an R/O with wood trim. Do we have to remove the wood R/O before we install the windows or do the windows sit in this opening?

1 Answers 11 Views

What type of wood is used in the platform?

1 Answers 4 Views

Can I carve wood so it won't be attached to the piece of wood I'm working on?

1 Answers 4 Views

My lower back really hurts after doing lunges. What am I doing wrong?

1 Answers 4 Views

Do you always have to use a piece of graph paper, or is using a piece of plain paper okay as well?

1 Answers 4 Views

Can I just glue a piece of black and a piece of white paper together?

1 Answers 4 Views

score 2629 · Accepted Answer · 2019-06-17T08:12:42+06:00

Dr. Md Rushad Rahman

এমবিবিএস(আরপিএমসি) , পিজিটি(মেডিসিন)

ইন্ডোর মেডিকেল অফিসার রংপুর কমিউনিটি মেডিকেল কলেজ হাসপাতাল,রংপুর সাধারণ চিকিৎসক প্রধান মেডিকেল সেন্টার,ঢাকা ক্যান্টনমেন্ট,ঢাকা বিএমডিসি রেজিস্টার.নং. এ-১02864

About 1- 1 1/2 inch if doing relief carvings on pine, and about 2 inches on basswood. If you're doing it on butternut, then about 1/2 inch

4 views Answered 2019-06-17 08:12