What do I need to do to a master cylinder before installing it on a car?

The new master comes with two clear rubber hoses and two plastic nipples that screw into the holes where you would put the brake lines. Screw and tighten the nipples. Fill the master cylinder with fluid. Put one rubber hose in each chamber of the master, and then connect them to the nipples. You need to place the master in a vise, in the round part in the back of cylinder between the two holes where it bolts on. Use a Phillips screwdriver and pump it -- it will be really hard to push, but push until you no longer see bubbles in the clear hoses. Make sure the hoses stay in the fluid -- you may need to have someone hold them while you pump.