How do I cut a fish into fish steaks?

Md Ariful Islam

বিএসসি(সিএসই) , এমবিএ(মার্কেটিং)

সফটওয়্যার ইঞ্জিনিয়ার Bissoy.com

5 views

2025-01-04 04:42

1 Answers

Dr. Md Rushad Rahman

এমবিবিএস(আরপিএমসি) , পিজিটি(মেডিসিন)

ইন্ডোর মেডিকেল অফিসার রংপুর কমিউনিটি মেডিকেল কলেজ হাসপাতাল,রংপুর সাধারণ চিকিৎসক প্রধান মেডিকেল সেন্টার,ঢাকা ক্যান্টনমেন্ট,ঢাকা বিএমডিসি রেজিস্টার.নং. এ-১02864

Clean it following the steps above, then cut off the head. Starting from that cut, measure back 1 inch and cut through the whole fish. One-inch thick is the recommended portion width—after pan-frying for seven minutes on each side over medium/high heat in a nicely oiled pan, it will be cooked to perfection!

5 views Answered 2016-10-08 08:12

Related Questions

What is the difference between cut five and cut six?

1 Answers 5 Views

The leaves of my aloe vera plant are no longer fleshy and succulent but thin. The lower leaves are drooping. Should I cut the plant above the drooping leaves and will it form new roots from where I cut the main stem?

1 Answers 8 Views

My Dracaena is about 12 or more feet tall and has bent over badly. Can I cut the tops off and replant them? If I cut the trunks back will I get new growth?

1 Answers 5 Views

I have a garter snake in my fish pond and I'm hoping my fish are too large for it to eat. How large a fish can a medium sized garter snake eat?

1 Answers 5 Views

I have a double metal door into a utility room in the basement of my home. The threshold base is a piece of wood which is badly rotted. There is a plastic strip attached to the wood base which is in a channel cut into the cement floor, about and inch and one half deep. How do I repair it?

1 Answers 4 Views

If the fish has a small mouth I can't get the pliers in the mouth and I can't see what to do with the disgorger, do I cut the line? I just worry that it will be uncomfortable for the fish or will lead to its death.

1 Answers 5 Views

I have a Ryobi battery-operated chainsaw that, when I try to cut a straight cut log end tends to cut in an arc. Why is this?

1 Answers 8 Views

I can't cut after getting HM cut. Why is this?

1 Answers 5 Views

Can a hollow core interior door be cut at the bottom so that I can put new vinyl over existing vinyl? How much can be cut at the bottom?

1 Answers 4 Views

The top corner is a 90-degree angle, so the ends of the pieces should each get a 45-degree cut, but the bottom two angles themselves are each 45 degrees, therefore the cut must be half of 45 degrees, correct?

1 Answers 5 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)