Wire bond resistors are made by

Question

Wire bond resistors are made by

Wire bond resistors are made by
A. winding the wires of an alloy viz, Cu,Al,Ag
B. winding the wires of an alloy viz, Si,Tu,Fe
C. winding the wires of an alloy viz, Ge,Au,Gr
D. winding the wires of an alloy viz,magnesium, constantan, nichrome

Monjur Alahi

4 views

2025-01-04 04:42

1 Answers

Related Questions

For the reaction, `2H_(2)+O_(2) to 2H_(2)O,DeltaH=571.` bond energy of H-H=435, O=O=498, then calculate the average bond energy of O-H bond using the

2 Answers 4 Views

The length of a wire is increased by 1 mm due to applied load. The wire of the same material have lengths and radius half that of the first wire, by t

2 Answers 4 Views

U - shaped film of a liquid is formed between a wire frame and movable wire 5 cm long. Then the force required to hold the wire in equilibrium is , (S

2 Answers 7 Views

A metal wire of diameter 1mm is held on two knife edges separated by a distance of 50cm . The tension in the wire is 100 N. the wire vibrates with its

2 Answers 5 Views

Two different wire A and B of same cross sectional area are joined to form a composite wire of length 1.5m of which wire A is 0.6 m and the rest is wi

2 Answers 4 Views

A metal wire is held at the two ends of rigid supports at `20^@C`, the wire is just . The speed of transverse wave in this wire at `25^@C` will be `(a

2 Answers 4 Views

Out of the following which pentadiens shows double bond character between `C_(2) -C(3)` bond although it appers to be a single bond

2 Answers 5 Views

Give reasons : (i) `PCl_(5)` is more volatile than `PCl_(3)`. (ii) O-O bond has lower bond dissociation enthalpy than S-S bond. (iii) `F_(2)` is stron

2 Answers 8 Views

Assertion : Si-Si bond is stronger than Si-O bond. Reason: Silicon form Si-Si bond easily.

2 Answers 4 Views

The heat of combustion of ethene gas is 330 Kcal `"mol"^(-1)` calculate `gtc=clt` bond energy (in kcal/mol) assuming that bond energy of C-H bond is 9

2 Answers 5 Views

Salim Ahmed Kawsar · Accepted Answer · 2023-02-05T15:29:48+06:00

Correct Answer - D
Wire bound reistors are made by winding the wires of an alloy viz. magnanin, constantan, nichrome etc. The choice of these materials is dicated mostly by the fact that their reistivities are relatively insensitive to temperature. These resistance are typeically in range of a fraction of an ohm to a few hundred ohms.