Which of the following method used for measuring high resistance (Given: above 100kΩ)?

Megger Method
Ohmeter Method
Potentiometer Method
Wheat stone bridge Method

LohaHridoy

4 views

2025-01-04 04:42

1 Answers

AhmedNazir

Option 1 : Megger Method

The Measurement of Resistance according to classification is shown below:

-	Low Resistance	Medium Resistance	High Resistance
Value	R ≤ 1 Ω	1 to 100 kΩ	R > 100 kΩ
Example	Ammeter internal resistance, Electrical machine winding resistance, Earthing resistance, Diode FB resistance, etc	DC Machine shunt winding resistance, heater coil resistance, Human body under normal condition resistance, etc	Cable insulation resistance, winding insulation resistance, Diode RB resistance, etc
Method of Measurement	1. Potentiometer 2. Kelvin Bridge	1. VA Method 2. Substitution rule 3. Wheatstone Bridge 4. Ohm-meter	1. Loss of charge Method 2. Megger 3. Mega-ohm bridge 4. Direct deflection

4 views Answered 2022-09-04 04:29

Related Questions

Which of the following statements is/are correct 1. A fuse wire is made of 37% lead and 63% tin 2. A fuse wire is made of 63% lead and 37% tin 3. A fuse wire has high resistance and low melting point 4. A fuse wire has low resistance and high melting point?

1 Answers 4 Views

Of the four characteristic given below, which are the major requirements for an instrumentation amplifier P: High common mode rejection ratio Q: High input impedance R: High linearity S: High output impedance?

1 Answers 5 Views

Which of the following advantages are there for a Darlington pair compared with a single transistor i) High current gain ii) High input resistance iii) High voltage gain iv) High bandwidth?

1 Answers 4 Views

With reference to 'fuel cells' in which hydrogen-rich fuel and oxygen are used to generate electricity, consider the following statements: 1. If pure hydrogen is used as a fuel, the fuel cell emits heat and water as by-products. 2. Fuel cells can be used for powering buildings and not for small devices like laptop computers. 3. Fuel cells produce electricity in the form of Alternating Current (AC) Which of the statements given above is/are correct?

1 Answers 4 Views

In the two sets given below, Set – I specifies the methods of research while Set – Il describes the critical feature associated with a method of research. Match the two and select from the code to indicate your answer. Set – I (Research method) Set – II (Critical features associated) (a) Experimental method (i) Generalizing to the population from a large sample (b) Ex post facto method (ii) Establishing the patterns of events which have happened, through primary and secondary sources (c) Historical method (iii) Studying shared behaviour patterns (d) Ethnographic method (iv) Establishing cause and effect through control (v) Probing into the causal factors from the observed effects ?

1 Answers 6 Views

Match List I with List II: List I (Method) List II (Purchase consideration) (A) Lump-sum payment method (I) Calculated by adding up the total amount (money value) of existing shares, preference shares and cash received from the purchasing company for the shareholders of the vendor company. (B) Net Assets Method (II) On the basis of ratio in which the shares of the transferee company are to be exchanged for the shares of the transferor company. (C) Net Payment Method (III) The amount to be paid by the transferee company to transferor company for amalgamation of its business. (D) Swap Ratio Method (IV) Arrived at by adding the agreed value of assets taken over and deducting there from the agreed values of liabilities. Choose the correct answer from the options given below:?

1 Answers 7 Views

Among the following flow measuring equipments, identify the equipment which cannot be used for measuring the discharge through pipes.?

1 Answers 4 Views

Which of the following is method of measuring spot speeds I. Enoscope method II. Photographic method?

1 Answers 5 Views

Which among the following are generally accepted methods of accounting for price level changes A. Replacement Cost Method B. Current Purchasing Power Method C. Opportunity Cost Method D. Current Cost Accounting Method E. Standard Cost Method Choose the correct answer from the options given below:?

1 Answers 4 Views

A bill for ₹1,840 is paid in the denominations of ₹50, ₹20 and ₹10 notes. 50 notes in all are used. Consider the following statements : 1. 25 notes of ₹50 are used and the remaining are in the denominations of ₹20 and ₹10. 2. 35 notes of ₹20 are used and the remaining are in the denominations of ₹50 and ₹10. 3. 20 notes of ₹10 are used and the remaining are in the denominations of ₹50 and ₹20. Which of the above statements are not correct ?

1 Answers 8 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)