Assuming both the voltage sources are in phase, the value of R for which maximum power is transferred from circuit A to circuit B is?

0.8 Ω
1.4 Ω
2 Ω
2.8 Ω

LohaHridoy

4 views

2025-01-04 04:42

1 Answers

AhmedNazir

Option 1 : 0.8 Ω

We obtain Thevenin equivalent of circuit B

= 0

⇒ R = 0.8 Ω

4 views Answered 2022-09-04 04:29

Related Questions

If an 8 Ω lamp resistance is connected to an electric circuit which has a battery voltage of 50 V, then calculate the power of the electric circuit.?

1 Answers 4 Views

Statements followed by some conclusions are given below. Statements: 1. Depleting natural resources is a major concern in our country. 2. Unless we go for renewable energy sources in a big way, increase in population being a heavy burden on the energy resources, will reduce the quality of life. Conclusions: I. Depleting resources impacts quality of life. II. Use of renewable energy sources is a solution to counter increase in population. Find which of the given conclusions logically follows from the given statements.?

1 Answers 5 Views

Two voltage sources of 12 V, each of which can be loaded up to 10 A, are connected in parallel. Which of the following statements about the circuit is true?

1 Answers 4 Views

Engines are rated at specified conditions. Then which of the following statements are correct 1. Power developed increases as local temperature increases. 2. Power developed increases as local temperature decreases 3. Power developed is not dependent on local temperature. 4. Power developed increases as local atmospheric pressure increases. 5. Power developed increases as local atmospheric pressure decreases.?

1 Answers 5 Views

A circuit breaker is a piece of equipment which can (i) make or break a circuit either manually or by remote control under normal conditions. (ii) break a circuit automatically under fault conditions. (iii) make a circuit either manually or by remote control under fault conditions Choose the correct answer. ?

1 Answers 4 Views

In which type of compound generator, the terminal voltage rises with an application of load so that its full load voltage exceeds its no-load voltage?

1 Answers 5 Views

There are two containers X and Y. X contains 100 ml of milk and Y contains 100 ml of water. 20 ml of milk from X is transferred to Y. After mixing well, 20 ml of the mixture in Y is transferred back to X. If m denotes the proportion of milk in X and n denotes the proportion of water in Y, then which one of the following is correct?

1 Answers 4 Views

The following statements are made regarding the Open Circuit Test on the single-phase transformer: 1. It is performed on the LV side. 2. It is performed at rated current. 3. It helps in the calculation of equivalent leakage impedance. 4. It is performed on the HV side. 5. It is performed at rated voltage. 6. It gives magnetizing current and core loss. 7. It helps in the determination of voltage regulation. 8. It gives the turn ratio. From these, which statements are correct?

1 Answers 4 Views

Which type of connection is used for both large voltage and low voltage rating transformers?

1 Answers 7 Views

In hydro power station which components is used to step up the generating voltage to a suitable transmission voltage?

1 Answers 4 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)