An Op-Amp can be connected to provide 1. Voltage controlled current source 2. Current controlled voltage source 3. Current controlled current source Which of the above statements are correct?

1 and 2 only
1 and 3 only
2 and 3 only
1, 2 and 3

LohaHridoy

10 views

2025-01-04 04:42

1 Answers

AhmedNazir

Option 4 : 1, 2 and 3

Based on the application, an Op-amp can be connected to provide:

1) Voltage control current source, in which the output current is controlled by the input voltage.
i.e. I₀ = KV_i
This relation is useful during the calculation of the Transconductance of the amplifier.

2) Current control voltage source, in which output voltage is control by the input current.
i.e. V_o = KI_i and it is useful to calculate the input impedance of the amplifier.

3) Current control current source, in which the output current is controlled by the input current.
i.e. I_o = KI_i and it is useful to calculate the current gain of the amplifier.

4) Voltage control voltage source in which output voltage is control by the input voltage.
i.e. V_o = KV_i and it is useful to calculate the voltage gain of the amplifier.

10 views Answered 2022-09-04 04:29

Related Questions

For thyristor operation, following statements are given: (i) The supply voltage must be greater than the forward break overvoltage. (ii) The supply voltage must be less than the forward break overvoltage. (iii) ILatching < Iholding (iv) ILatching > Iholding Which of the above statements are correct Choose the correct answer from the code given below:?

1 Answers 4 Views

In which ratio the two mocktails A & B containing flavoured liquids x & y in 6 ∶ 5 & 7 ∶ 15 be mixed to get equal amount of x & y in the resultant mixture?

1 Answers 4 Views

Consider the following statements: Any element is redundant if connected in a) series with an ideal current source b) parallel with an ideal current source c) series with an ideal voltage source d) parallel with an ideal voltage source Which of the above statements are correct?

1 Answers 7 Views

Consider the following statements Pharmacopoeia Commission for Indian Medicine & Homoeopathy 1. Pharmacopoeia Commission for Indian Medicine & Homoeopathy (PCIM&H) as Subordinate Office under Ministry of AYUSH 2. It was established in 2019. 3. The Commission serves as an umbrella organization for Ayurvedic Pharmacopoeia Committee (APC), Siddha Pharmacopoeia Committee (SPC), Unani Pharmacopoeia Committee (UPC) and Homoeopathic Pharmacopeia Committee (HPC) Which of the above statements is/are correct?

1 Answers 4 Views

Consider the following statements: Sphere gap method of voltage measurement is used 1. for measuring r.m.s. value of a high voltage 2. for measuring peak value of a high voltage 3. as the standard for calibration purposes Which of the above statements are correct?

1 Answers 4 Views

Consider the following statements: Phase controlled converters at small values of output voltage have 1. Large harmonics in utility system 2. Poor power factor 3. High efficiency 4. Notches in line voltage waveform Which of the above statements are correct?

1 Answers 5 Views

The following statements refer to an n channel FET operated in the active region: 1. The gate voltage VGS reverse biases the junction 2. The drain voltage VDD is negative with respect to the source 3. The current in the n channel is due to electrons 4. Increasing the reveres bias VGS increases the cross section for conduction Which of these statements are correct?

1 Answers 4 Views

Consider the following statements: Any element connected in 1. Series with an ideal current source is redundant. 2. Parallel with an ideal current source is redundant. 3. Series with an ideal voltage source is redundant. 4. Parallel with an ideal voltage source is redundant. Which of the above statements is/are correct?

1 Answers 7 Views

Which of the following network theorem deals with finding out the circuit values of voltage and current in a restricted portion of the network by replacing the actual source of energy by a single “equivalent voltage source” or by a “equivalent current source” acting at a terminal pair?

1 Answers 4 Views

Consider the following statements about IGBT 1. It has high input impedance 2. It has low ON state voltage drop 3. Its switching speed is higher than that of the MOSFET 4. It is a voltage controlled device Which of the above statements are correct?

1 Answers 5 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)