Depending on what type of plastic it is, it probably will stick to it. You can put parchment paper sheets between the mold to avoid this, but the heat from...
1 Answers 1 viewsTake a clean sink, put a stopper in it, and place the bottle in hot water from the tap. You might have to give it about 30 minutes to thaw...
1 Answers 1 viewsI don't think you should use a cast iron pan but it could work if you are desperate. I would definitely use a gas stove.
1 Answers 1 viewsNo, the table cloth is not strong enough and will rip. Also, it is likely not long enough.
1 Answers 1 viewsThat would really just be a large spray bottle. If you were looking for a water gun with more capacity, I would recommend sizing up the whole project to larger...
1 Answers 1 viewsTape will not last as long as glue, especially a glue made for paper. There's no reason you can't use origami paper, though.
1 Answers 1 viewsMost offer an easy push-to-eject function that, if pushed just right, will allow the foot to come out without breaking. Give it a little more force, and with the end...
1 Answers 1 viewsTry using a pair of pliers on the plastic and a screw driver on the screw. Turn screw counterclockwise to remove. Repeat for each screw.
1 Answers 1 viewsIt shouldn't be a problem. Usually D string magnets are raised higher than the others.
1 Answers 1 views